On Wed, Dec 24, 2008 at 5:20 AM, Corey Osgood corey.osgood@gmail.comwrote:
On Wed, Dec 24, 2008 at 5:09 AM, ron minnich rminnich@gmail.com wrote:
On Wed, Dec 24, 2008 at 12:14 AM, Corey Osgood corey.osgood@gmail.com wrote:
*phew* I was worried that was how v3 was always going to run. As for
those
times Ron, stage0 takes <1 second, initram is ~5 seconds,
the initram seems way too long. But that stage 2 tells me you have some real problems with your dram setup.
It could have been less, timing output from a serial port with a stopwatch isn't very exact. I don't think there's anything wrong with the dram setup, I ran memtest86 overnight without any errors.
I know nothing about this part. I wonder if you could dump your mtrr
settings and let us see them.
Sure, what point do you want them from? End of stage1?
Here's a boot log that dumps them right after serial comes up, again just before disable_car(), and once more before loading stage2. After that mtrrs aren't touched until stage 2 phase 6 AFAIK. I wish I knew more about this stuff, I should probably make some time to read those Intel x86 programming guides.
Thanks, Corey