23 Feb
2004
23 Feb
'04
11:18 a.m.
Aagh !
Ignore the following files in the archive, as they are not required:
src/include/cpu/stpc/elite/stpc_conf-notused.h src/cpu/stpc/elite/stpc_framebuffer.inc
Ta.
--
Peter Fox peter.fox@aeroflex.com Aeroflex Test Solutions
Principal Design Engineer Stevenage
Any opinions expressed above are http://www.aeroflex.com/
not necessarily those of Aeroflex. Tel: + 44 (0) 1438 742200
-----Original Message-----
From: Peter Fox [mailto:peter.fox@aeroflex.com]
Sent: 23 February 2004 15:29
To: Linuxbios
Subject: Freebios1 STPC Elite development board changes attached
Please find attached my changes to support the STPC Elite
processor, and the mainboard/elite build configuration for
the STPC Elite development board.
These changes are for freebios1. They are mostly copies
of the consumer-II stuff by Steve M. Gehlbach, but modified
to remove all the graphics stuff, as the Elite has no
graphics controller, and to add initialisation for the
GP clock etc.
I've also put in the bit-bashing SPD code for the Elite,
though I don't use it on the development mainboard.
I can run Redhat 7.1 fine (serial console only) using filo as
the payload. This is using the 20/01/2004 snapshot for other
files.
--
Peter Fox peter.fox@aeroflex.com Aeroflex Test Solutions
Principal Design Engineer Stevenage
Any opinions expressed above are http://www.aeroflex.com/
not necessarily those of Aeroflex. Tel: + 44 (0) 1438 742200