Dear Roman,
Am Samstag, den 28.07.2012, 15:15 +0400 schrieb Roman Elshin:
Hi, I think my problem while using cimx are reset related, looking on log of my experiments with sb800 (where more success), I see that first initialisation always finished by ...WARM RESET..., and starts after it. With cimx it can not start after WARN RESET, (same way as after hard reset button), it stops with zero post code, and can begin initialization only after power off/on sequence. Can one give some direction how to find solution?
While playing with bit0,bit1 of SB_MISC_REG84, from my mistake, original flash chip (it is winbond w25q32) was programmed by coreboots content. There was used at25df321a (which are able to boot original bios without such problem) for it before. And this problem are gone (only chip replacement was enough).
were you able to make further progress on your ASRock 880G Pro3 [1]?
Currently Sebastian tries to convert the board ASUS M5A88V Evo [2] from the generic coreboot code, which just supports Family 10h processors, to AMD AGESA/CIMx code. Currently he is stuck with SATA problems. So if you have any input/ideas, it would be awesome if you could report back.
Thanks,
Paul
[1] http://www.asrock.com/mb/AMD/880G%20Pro3/ [2] http://www.asus.com/Motherboards/M5A88V_EVO/