Can you email me the log. Since I don't have epia right, reading the log is the best I can do.
-Andrew
On Thu, Oct 02, 2003 at 09:45:53AM -0600, ron minnich wrote:
On Thu, 2 Oct 2003, Andrew Ip wrote:
Hi,
Kevin did this fine job in v1. Basically it assigns irqs for PCI devices in case of PIRQ table doesn't work. I have been using in different place. I also think it would be nice to do it in config file instead of in source just like geode. Ron, does epia work now?
I'm not getting any ethernet interrupts. The packets get out, they get responsded to, but the node never gets the interrupt.
Also, I get these messages after a while: eth0: Transmit timed out, status 1003, PHY status 786d, resetting...
I assume this means no TX IRQ. Blast. What do I look for?
ron