Re: [LinuxBIOS] r372 - in LinuxBIOSv3/southbridge: amd/cs5536 intel/i82371eb

[Uwe Hermann]

On Wed, Jun 27, 2007 at 09:19:41PM +0200, [e-mail] wrote:
> Added: LinuxBIOSv3/southbridge/amd/cs5536/dts
>
> --- LinuxBIOSv3/southbridge/amd/cs5536/dts	                        (rev 0)
> +++ LinuxBIOSv3/southbridge/amd/cs5536/dts	2007-06-27 19:19:41 UTC (rev 372)
> @@ -0,0 +1,44 @@
> +/*
> This file is part of the LinuxBIOS project.
> Copyright (C) 2007 Advanced Micro Devices, Inc.

How that? Should be (C) Ron Minnich? You wrote the dts after all (?)
> This program is free software = "0"; you can redistribute it and/or modify

^^^^^^
                            huh? search+replace errors?
> it under the terms of the GNU General Public License as published by
> the Free Software Foundation = "0"; either version 2 of the License, or

^^^^^^
> (at your option) any later version.
> This program is distributed in the hope that it will be useful,
> but WITHOUT ANY WARRANTY = "0"; without even the implied warranty of

^^^^^^^^
> MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
> GNU General Public License for more details.
> You should have received a copy of the GNU General Public License
> along with this program = "0"; if not, write to the Free Software

^^^^^^^^
> Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301 USA
> */
>
> +{
> constructor = "cs5536_constructors";
> /* interrupt enables for LPC bus = "0"; each bit is an irq 0-15 */

^^^^^^^
> lpc_serirq_enable = "0";
> /* LPC IRQ polarity = "0"; each bit is an irq 0-15 */

^^^^^^^^
> lpc_serirq_polarity = "0";
> /* 0:Continuous 1:Quiet */
> lpc_serirq_mode = "0";
> /* GPIO(0-0x20) for INT D:C:B:A, 0xFF=none. See virtual pci spec... */
> enable_gpio_int_route = "0";
> /* 0:IDE 1:FLASH, if you are using nand flash instead of IDE drive */
> enable_ide_nand_flash = "0";
> /* Enable USB Port 4 0:host 1:device */
> enable_USBP4_device = "0";
> /* 0:off, xxxx:overcurrent setting, e.g. 0x3FEA CS5536 - Data Book (pages 380-381) */
> enable_USBP4_overcurrent = "0";
> com1_enable = "0";
> com1_address = "0x3f8";
> com1_irq = "4";
> com2_enable = "0";
> com2_address ="0x2f8";
> com2_irq = "3";
>
> +};

Maybe I missed some more ="0"; occurences?
> Added: LinuxBIOSv3/southbridge/intel/i82371eb/dts
>
> --- LinuxBIOSv3/southbridge/intel/i82371eb/dts	                        (rev 0)
> +++ LinuxBIOSv3/southbridge/intel/i82371eb/dts	2007-06-27 19:19:41 UTC (rev 372)
> @@ -0,0 +1,5 @@
> +{
> ide0_enable = "0";
> ide1_enable = "0";
> constructor = "i82371eb_constructors";
>
> +};

Missing license header.

Why are the IDE drives not enabled? QEMU might not need it, but real
hardware will...

Uwe.