Hello!
I have some troubles with southbridge i82801gx.
I can boot Windows on my board, but S3 from OS doesn't work properly if i resume with USB keyboard.
In this case, i have Wake signal and coreboot starts to boot, but it stucks with endless messages about SMI# "GPE0_STS: USB1":
..
SMI# #0 GPE0_STS: USB1
SMI# #0 GPE0_STS: USB1
SMI# #0 GPE0_STS: USB1
...
These messages come from file "\southbridge\intel\i82801gx\smihandler.c", function "dump_gpe0_status".
According to i82801gx datasheet: ___
USB1_STS - R/WC. Software clears this bit by writing a 1 to it. 0 = USB UHCI controller 1 does Not need to cause a wake.
1 = Set by hardware when USB UHCI controller 1 needs to cause a wake. Wake event
will be generated if the corresponding USB1_EN bit is set.
___
Clearing of GPE0_STS bits properly done in function reset_gpe0_status
/** * @brief read and clear GPE0_STS * @return GPE0_STS register */ static u32 reset_gpe0_status(void) { u32 reg32;
reg32 = inl(pmbase + GPE0_STS); /* set status bits are cleared by writing 1 to them */ outl(reg32, pmbase + GPE0_STS);
return reg32; }
So... i can't really understand, why does this SMI# appear again and again?
Thanks, Aladyshev Konstantin.