We should separate the it8718f_24mhz_clkin like the way 8712 does.
Signed-off-by: Zheng Bao zheng.bao@amd.com
Index: src/superio/ite/it8718f/it8718f_early_serial.c =================================================================== --- src/superio/ite/it8718f/it8718f_early_serial.c (revision 449) +++ src/superio/ite/it8718f/it8718f_early_serial.c (working copy) @@ -45,10 +45,9 @@ outb(value, SIO_DATA); }
-/* Enable the peripheral devices on the IT8718F Super I/O chip. */ -static void it8718f_enable_serial(device_t dev, unsigned iobase) +static void it8718f_enter_conf(void) { - /* (1) Enter the configuration state (MB PnP mode). */ + /* Enter the configuration state (MB PnP mode). */
/* Perform MB PnP setup to put the SIO chip at 0x2e. */ /* Base address 0x2e: 0x87 0x01 0x55 0x55. */ @@ -57,7 +56,30 @@ outb(0x01, IT8718F_CONFIGURATION_PORT); outb(0x55, IT8718F_CONFIGURATION_PORT); outb(0x55, IT8718F_CONFIGURATION_PORT); +}
+static void it8718f_exit_conf(void) +{ + /* Exit the configuration state (MB PnP mode). */ + it8718f_sio_write(0x00, IT8718F_CONFIG_REG_CC, 0x02); +} + +static void it8718f_24mhz_clkin(void) +{ + it8718f_enter_conf(); + + /* Select 24MHz CLKIN (48MHZ default)*/ + it8718f_sio_write(0x00, IT8718F_CONFIG_REG_CLOCKSEL, 0x1); + + it8718f_exit_conf(); +} + +/* Enable the peripheral devices on the IT8718F Super I/O chip. */ +static void it8718f_enable_serial(device_t dev, unsigned iobase) +{ + /* (1) Enter the configuration state (MB PnP mode). */ + it8718f_enter_conf(); + /* (2) Modify the data of configuration registers. */
/* Select the chip to configure (if there's more than one). @@ -65,17 +87,14 @@ If this register is not written, both chips are configured. */ /* it8718f_sio_write(0x00, IT8718F_CONFIG_REG_CONFIGSEL, 0x00); */
- /* Enable all devices. */ + /* Enable serial port(s). */ it8718f_sio_write(IT8718F_SP1, 0x30, 0x1); /* Serial port 1 */ it8718f_sio_write(IT8718F_SP2, 0x30, 0x1); /* Serial port 2 */
- /* Select 24MHz CLKIN (set bit 0). */ - it8718f_sio_write(0x00, IT8718F_CONFIG_REG_CLOCKSEL, 0x01); - /* Clear software suspend mode (clear bit 0). TODO: Needed? */ /* it8718f_sio_write(0x00, IT8718F_CONFIG_REG_SWSUSP, 0x00); */
/* (3) Exit the configuration state (MB PnP mode). */ - it8718f_sio_write(0x00, IT8718F_CONFIG_REG_CC, 0x02); + it8718f_exit_conf(); }