Hi, thanks! Now 2 strange things happen for both suggestions: 2011/10/26 Kyösti Mälkki kyosti.malkki@gmail.com
reg32 = sch_port_access_read(4, 0x71, 2); reg32 &= 0x700; reg32 = reg32 >> 7;
Probably should read: reg32 &= 0x700; reg32 = reg32 >> 8;
------------ Serial output ------------
US15W Chipset
Unknown (07)Setting up ACPI PM1 block Setting up ACPI P block done.
Setting up RAM controller. READ BASE_ADDR=fffc0000
Setting up RAM
Setting up RAM
Setting up RAM -- continuously prints "Setting up RAM" line..
Ok I get passed the "Setting up RAM controller." now, but stuck now in "Setting up RAM" as can be seen above I print the detected softstrap base, and it says fffc0000.
or (not so likely) reg32 &= 0x380; reg32 = reg32 >> 7;
And for this the same happens with fffe0000 address detected as softstrap base?
------------ Serial output ------------
US15W Chipset
Unknown (07)Setting up ACPI PM1 block Setting up ACPI P block done.
Setting up RAM controller. READ BASE_ADDR=fffe0000
Setting up RAM
Setting up RAM
Setting up RAM -- continuously prints "Setting up RAM" line..
I didn't get what's going on. So which one is correct to use? But both are stuck at "Setting up RAM" line.. Thanks in advance, Alp