It's OK.
PCI: 04:01.0 bridge ctrl <- 0003 PCI: 04:01.0 cmd <- 146 PCI: 05:04.0 cmd <- 142 PCI: 04:01.1 subsystem <- 10f1/2895 PCI: 04:01.1 cmd <- 146 PCI: 04:02.0 bridge ctrl <- 0003 PCI: 04:02.0 cmd <- 147 PCI: 06:06.0 cmd <- 143 PCI: 06:06.1 cmd <- 143
-----Original Message----- From: YhLu Sent: Thursday, October 21, 2004 12:11 PM To: 'ebiederman@lnxi.com' Cc: LinuxBIOS Subject: RE: Freebios2 recovery progress...
I will test that on s2885.
I suspect that will need MEM enable too.
YH
-----Original Message----- From: ebiederman@lnxi.com [mailto:ebiederman@lnxi.com] Sent: Thursday, October 21, 2004 11:39 AM To: YhLu Cc: LinuxBIOS Subject: Re: Freebios2 recovery progress...
YhLu YhLu@tyan.com writes:
You can not test that in arima board. Because all device on 8131 is using ioapic in amd8111.
I can't test that it works but I can test that the bits are getting set by running lspci. And that is how I tested. The bus master bit is still getting set. I just move the location.
Eric