On Wed, Sep 14, 2011 at 07:45:59AM -0400, Amos Kong wrote:
The size of bios.bin compiled from seabios original: 128K only apply patch1: 256K only apply patch2: 128K
patch1: add 6 slot(only slot6 has 8 funcs) to the table can hotplug/hot-remove a multifunc device to slot 6 successfully
patch2: add 31 slot(with 8 funcs) to the table could not boot up guest. I found there is a special process for large bios.bin in qemu, problem maybe exist here, I'm driving into it...
qemu/hw/pc.c: void pc_memory_init(... .... /* map the last 128KB of the BIOS in ISA space */ isa_bios_size = bios_size; if (isa_bios_size > (128 * 1024)) isa_bios_size = 128 * 1024;
This is probably a regression since seabios commit 87b533bf. Prior to that commit, seabios did not mark the early 32bit initialization code as init code. However, a side effect of marking that code (handle_post) as init code is that it is more likely the linker could place the code at an address less than 0xe0000.
I'm guesing the patch below (just a hack) would cover up the issue.
-Kevin
--- a/src/post.c +++ b/src/post.c @@ -336,7 +336,7 @@ reloc_init(void) // Start of Power On Self Test (POST) - the BIOS initilization phase. // This function does the setup needed for code relocation, and then // invokes the relocation and main setup code. -void VISIBLE32INIT +void VISIBLE32FLAT handle_post(void) { debug_serial_setup(); @@ -356,6 +356,14 @@ handle_post(void)
// Allow writes to modify bios area (0xf0000) make_bios_writable(); + + void handle_post2(void); + handle_post2(); +} + +void VISIBLE32INIT +handle_post2(void) +{ HaveRunPost = 1;
// Detect ram and setup internal malloc.
-
Kevin O'Connor