[CC’ing coreboot, GRUB, SeaBIOS, Syslinux project and Linux kernel]
Am Montag, den 16.03.2015, 11:38 +0100 schrieb Kay Sievers:
On Mon, Mar 16, 2015 at 11:29 AM, Umut Tezduyar
I would like to pass the time it was spent in
bootloader to systemd.
Is there a kernel command line to pass this information on non EFI
bootloader? Or is there an another way?
No, there isn't anything I know of.
The kernel boot protocol should probably be extended to accept a block
of values to be passed from the loader to the OS, and be exported
somewhere by the kernel itself to userspace.
Overloading the kernel command line with that does not sound like the
right approach. We should not support anything like that from systemd.
Could that approach please be discussed with all firmware, payload and
firmware projects? For example, coreboot (and the depthcharge payload
used on Chromebooks and Chromeboxes) already store the time stamps in
its CBMEM, which can be read with the utility `cbmem` with `cbmem -t`
 or with GRUB’s `coreboot_boottime` command.
10 entries total:
10:start of ramstage 9
30:device enumeration 441 (432)
40:device configuration 95,357 (94,915)
50:device enable 99,275 (3,918)
60:device initialization 109,246 (9,971)
70:device setup done 181,906 (72,659)
75:cbmem post 182,274 (368)
80:write tables 182,276 (2)
90:load payload 183,873 (1,597)
99:selfboot jump 283,779 (99,905)
GRUB also has a `boottime` command outputting times like how long a
module needed to load.
One approach would be, that the Linux kernel has drivers to read the
different implementations on how to store the boot time and then exports
those to userspace.
The other approach, and probably more feasible one, is that all firmware
projects use the same standard/specification.
What is actually needed? Are pairs of
project, stage name, time in milliseconds since start of program
where each project gets assigned a unique ID. Do you need more data?