Use the pci_enable_x() functions.
The lsi-scsi controller code will now explicitly set PCI_COMMAND_IO instead of assuming it has already been enabled.
Signed-off-by: Kevin O'Connor kevin@koconnor.net --- src/hw/lsi-scsi.c | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-)
diff --git a/src/hw/lsi-scsi.c b/src/hw/lsi-scsi.c index ad33528..2629b5f 100644 --- a/src/hw/lsi-scsi.c +++ b/src/hw/lsi-scsi.c @@ -172,15 +172,14 @@ lsi_scsi_scan_target(struct pci_device *pci, u32 iobase, u8 target) static void init_lsi_scsi(struct pci_device *pci) { - u16 bdf = pci->bdf; - u32 iobase = pci_config_readl(pci->bdf, PCI_BASE_ADDRESS_0) - & PCI_BASE_ADDRESS_IO_MASK; - - pci_config_maskw(bdf, PCI_COMMAND, 0, PCI_COMMAND_MASTER); + u32 iobase = pci_enable_iobar(pci, PCI_BASE_ADDRESS_0); + if (!iobase) + return; + pci_enable_busmaster(pci);
dprintf(1, "found lsi53c895a at %02x:%02x.%x, io @ %x\n", - pci_bdf_to_bus(bdf), pci_bdf_to_dev(bdf), - pci_bdf_to_fn(bdf), iobase); + pci_bdf_to_bus(pci->bdf), pci_bdf_to_dev(pci->bdf), + pci_bdf_to_fn(pci->bdf), iobase);
// reset outb(LSI_ISTAT0_SRST, iobase + LSI_REG_ISTAT0);