[SeaBIOS] [PATCH 1/5] sdcard: Check if card is present before sending commands to card

[Kevin O'Connor]

Signed-off-by: Kevin O'Connor 
---
 src/hw/sdcard.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/src/hw/sdcard.c b/src/hw/sdcard.c
index d2c3288..7523ab8 100644
--- a/src/hw/sdcard.c
+++ b/src/hw/sdcard.c
@@ -73,8 +73,9 @@ struct sdhci_s {
 #define SI_READ_READY   (1<<5)

// SDHCI present_state flags
-#define SP_CMD_INHIBIT (1<<0)
-#define SP_DAT_INHIBIT (1<<1)
+#define SP_CMD_INHIBIT   (1<<0)
+#define SP_DAT_INHIBIT   (1<<1)
+#define SP_CARD_INSERTED (1<<16)

// SDHCI transfer_mode flags
 #define ST_BLOCKCOUNT (1<<1)
@@ -269,6 +270,10 @@ sdcard_controller_setup(void *data)
     if (!runningOnQEMU())
         // XXX - this init logic will probably only work on qemu!
         return;
+    u32 present_state = readl(&regs->present_state);
+    if (!(present_state & SP_CARD_INSERTED))
+        // No card present
+        return;
     writew(&regs->irq_signal, 0);
     writew(&regs->irq_enable, 0xffff);
     writew(&regs->error_signal, 0);