The problem with using floppy_motor_counter was that, after it reaches 0, it immediately stops the floppy motors, which is not what is supposed to happen on real hardware. Instead, after a timeout (like in the end of every floppy operation, regardless of the result - success, timeout or error), the floppy motors must be kept spinning for additional 2 seconds (the FLOPPY_MOTOR_TICKS). So, now the floppy_motor_counter is initialized to 255 (the max value) in the beginning of the floppy operation (in floppy_turn_on_motor()). For IRQ timeouts, a different timeout is used, specified by the new FLOPPY_IRQ_TIMEOUT constant (currently set to 5 seconds - a fairly conservative value, but should work reliably on most floppies).
After the floppy operation, floppy_turn_off_motor_delayed() resets the floppy_motor_counter to 2 seconds (FLOPPY_MOTOR_TICKS).
This is also consistent with what other PC BIOSes do.
Signed-off-by: Nikolay Nikolov nickysn@users.sourceforge.net --- src/hw/floppy.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/src/hw/floppy.c b/src/hw/floppy.c index acaff3f..6714402 100644 --- a/src/hw/floppy.c +++ b/src/hw/floppy.c @@ -34,6 +34,7 @@ #define FLOPPY_GAPLEN 0x1B #define FLOPPY_FORMAT_GAPLEN 0x6c #define FLOPPY_PIO_TIMEOUT 1000 +#define FLOPPY_IRQ_TIMEOUT 5000
#define FLOPPY_DOR_MOTOR_D 0x80 // Set to turn drive 3's motor ON #define FLOPPY_DOR_MOTOR_C 0x40 // Set to turn drive 2's motor ON @@ -221,8 +222,9 @@ floppy_wait_irq(void) { u8 frs = GET_BDA(floppy_recalibration_status); SET_BDA(floppy_recalibration_status, frs & ~FRS_IRQ); + u32 end = timer_calc(FLOPPY_IRQ_TIMEOUT); for (;;) { - if (!GET_BDA(floppy_motor_counter)) { + if (timer_check(end)) { warn_timeout(); floppy_disable_controller(); return DISK_RET_ETIMEOUT; @@ -340,8 +342,8 @@ floppy_enable_controller(void) static void floppy_turn_on_motor(u8 floppyid) { - // reset the disk motor timeout value of INT 08 - SET_BDA(floppy_motor_counter, FLOPPY_MOTOR_TICKS); + // set the disk motor timeout value of INT 08 to the highest value + SET_BDA(floppy_motor_counter, 255);
// Turn on motor of selected drive, DMA & int enabled, normal operation floppy_dor_write((floppyid ? FLOPPY_DOR_MOTOR_B : FLOPPY_DOR_MOTOR_A) | FLOPPY_DOR_IRQ | FLOPPY_DOR_RESET | floppyid);