Change in ...coreboot[master]: soc/intel/cannonlake: Configure GPIOs again after FSP-S is done

[Furquan Shaikh (Code Review)]

Hello Aaron Durbin, Patrick Rudolph, Duncan Laurie, Shelley Chen, build bot (Jenkins),

I'd like you to reexamine a change. Please visit

https://review.coreboot.org/c/coreboot/+/31250

to look at the new patch set (#4).

Change subject: soc/intel/cannonlake: Configure GPIOs again after FSP-S is done
......................................................................

soc/intel/cannonlake: Configure GPIOs again after FSP-S is done

FSP-S is currently configuring GPIOs that it should not. This results
in issues where mainboard devices don't behave as expected e.g. host
unable to receive TPM interrupts as the pad for the interrupt is
re-configured as something else.

Until FSP-S is fixed, this change adds a workaround by reconfiguring
GPIOs after FSP-S is run.

All mainboards need to call cnl_configure_pads instead of
gpio_configure_pads so that SoC code can maintain a reference to the
GPIO table and use that to re-configure GPIOs after FSP-S is run.

BUG=b:123721147
BRANCH=None
TEST=Verified that there are no TPM IRQ timeouts in boot log on hatch.

Change-Id: I7787aa8f185f633627bcedc7f23504bf4a5250b4
Signed-off-by: Furquan Shaikh 
---
M src/soc/intel/cannonlake/chip.c
M src/soc/intel/cannonlake/include/soc/gpio.h
2 files changed, 35 insertions(+), 1 deletion(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/50/31250/4