Change in coreboot[master]: mb/google/brya/var/felwinter: Enable garage pen detection

[EricR Lai (Code Review)]

EricR Lai has uploaded this change for review. ( https://review.coreboot.org/c/coreboot/+/59234 )

Change subject: mb/google/brya/var/felwinter: Enable garage pen detection
......................................................................

mb/google/brya/var/felwinter: Enable garage pen detection

Enable garage pen detection.

BUG=b:197912223
TEST=Check evtest can trigger event when toggling the switch.

Signed-off-by: Eric Lai 
Change-Id: Ib5929c876d1a0da34dadd7997a61ab8e75acbbb6
---
M src/mainboard/google/brya/Kconfig.name
M src/mainboard/google/brya/variants/felwinter/overridetree.cb
2 files changed, 13 insertions(+), 0 deletions(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/34/59234/1

diff --git a/src/mainboard/google/brya/Kconfig.name b/src/mainboard/google/brya/Kconfig.name
index 8d58fa5..8282489 100644
--- a/src/mainboard/google/brya/Kconfig.name
+++ b/src/mainboard/google/brya/Kconfig.name
@@ -60,6 +60,7 @@
 config BOARD_GOOGLE_FELWINTER
    bool "->  Felwinter"
    select BOARD_GOOGLE_BASEBOARD_BRYA
+	select DRIVERS_GENERIC_GPIO_KEYS

config BOARD_GOOGLE_ANAHERA
    bool "->  Anahera"
diff --git a/src/mainboard/google/brya/variants/felwinter/overridetree.cb b/src/mainboard/google/brya/variants/felwinter/overridetree.cb
index 4647551..8420452 100644
--- a/src/mainboard/google/brya/variants/felwinter/overridetree.cb
+++ b/src/mainboard/google/brya/variants/felwinter/overridetree.cb
@@ -101,6 +101,18 @@
    			register "hid_desc_reg_offset" = "0x01"
    			device i2c 10 on end
    		end
+			chip drivers/generic/gpio_keys
+				register "name" = ""PENH""
+				register "gpio" = "ACPI_GPIO_IRQ_EDGE_BOTH(GPP_A7)"
+				register "key.wake_gpe" = "GPE0_DW0_08"
+				register "key.wakeup_route" = "WAKEUP_ROUTE_SCI"
+				register "key.wakeup_event_action" = "EV_ACT_DEASSERTED"
+				register "key.dev_name" = ""EJCT""
+				register "key.linux_code" = "SW_PEN_INSERTED"
+				register "key.linux_input_type" = "EV_SW"
+				register "key.label" = ""pen_eject""
+				device generic 0 on end
+			end
    	end
    	device ref i2c3 on end
    	device ref i2c5 on