[coreboot-gerrit] Change in coreboot[master]: soc/intel/common: Set controller state to active in uart init

[Usha P (Code Review)]

Usha P has uploaded this change for review. ( https://review.coreboot.org/c/coreboot/+/34810 )

Change subject: soc/intel/common: Set controller state to active in uart init
......................................................................

soc/intel/common: Set controller state to active in uart init

Set the controller state to D0 during the uart init sequence, this
ensures the controller is up and active.

One more argument "const struct device *dev" has been added
to uart_lpss_init function for the same.

BUG=b:135941367
TEST=Verify no timeouts seen during UART controller enumeration
     sequence in CML, ICl and APL platforms

Change-Id: Ie91b502a38d1a40a3dea3711b015b7a5b7ede2db
Signed-off-by: Usha P 
---
M src/soc/intel/common/block/uart/uart.c
1 file changed, 6 insertions(+), 3 deletions(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/10/34810/1

diff --git a/src/soc/intel/common/block/uart/uart.c b/src/soc/intel/common/block/uart/uart.c
index f556aed..364835d 100644
--- a/src/soc/intel/common/block/uart/uart.c
+++ b/src/soc/intel/common/block/uart/uart.c
@@ -33,8 +33,11 @@
 extern const struct uart_gpio_pad_config uart_gpio_pads[];
 extern const int uart_max_index;

-static void uart_lpss_init(uintptr_t baseaddr)
+static void uart_lpss_init(const struct device *dev, uintptr_t baseaddr)
 {
+	/* Ensure controller is in D0 state */
+	lpss_set_power_state(dev, STATE_D0);
+
    /* Take UART out of reset */
    lpss_reset_release(baseaddr);

@@ -79,7 +82,7 @@
    /* Enable memory access and bus master */
    pci_write_config32(dev, PCI_COMMAND, UART_PCI_ENABLE);

-	uart_lpss_init(baseaddr);
+	uart_lpss_init(device, baseaddr);
 }

const struct device *uart_get_device(void)
@@ -231,7 +234,7 @@

base = pci_read_config32(dev, PCI_BASE_ADDRESS_0) & ~0xFFF;
    	if (base)
-			uart_lpss_init(base);
+			uart_lpss_init(dev, base);
    }
 }