Edward O'Callaghan (eocallaghan@alterapraxis.com) just uploaded a new patch set to gerrit, which you can find at http://review.coreboot.org/5580
-gerrit
commit f819ee46fd304a0aa51b521b5df7c7901741a7e0 Author: Edward O'Callaghan eocallaghan@alterapraxis.com Date: Sat Apr 26 15:21:45 2014 +1000
superio/fintek/f71869ad: Make hwm devicetree configurable
Provision the configuration of the Fintek F71869AD Hardware Monitor's configuration by way of devicetree.cb. Make use of this in the jetway/nf81-t56n-lf board to properly control fan's.
Change-Id: Ic25b29d1b7a9145e0e209b490b25a2cbc46cb75c Signed-off-by: Edward O'Callaghan eocallaghan@alterapraxis.com --- src/mainboard/jetway/nf81-t56n-lf/devicetree.cb | 12 +++ src/superio/fintek/f71869ad/Makefile.inc | 1 + src/superio/fintek/f71869ad/chip.h | 11 +++ src/superio/fintek/f71869ad/f71869ad_hwm.c | 112 ++++++++++++++++++++++++ src/superio/fintek/f71869ad/fintek_internal.h | 1 + src/superio/fintek/f71869ad/superio.c | 1 + 6 files changed, 138 insertions(+)
diff --git a/src/mainboard/jetway/nf81-t56n-lf/devicetree.cb b/src/mainboard/jetway/nf81-t56n-lf/devicetree.cb index 1c8853d..75184d4 100644 --- a/src/mainboard/jetway/nf81-t56n-lf/devicetree.cb +++ b/src/mainboard/jetway/nf81-t56n-lf/devicetree.cb @@ -61,6 +61,18 @@ chip northbridge/amd/agesa/family14/root_complex register "multi_function_register_3" = "0x24" register "multi_function_register_4" = "0x00" register "multi_function_register_5" = "0x60" +# HWM configuration registers + register "hwm_smbus_address" = "0x98" + register "hwm_smbus_control_reg" = "0x02" + register "hwm_fan_type_sel_reg" = "0x00" + register "hwm_fan1_temp_adj_rate_reg" = "0x33" + register "hwm_fan_mode_sel_reg" = "0x07" + register "hwm_fan1_idx_rpm_mode" = "0x0e" + register "hwm_fan1_seg1_speed_count" = "0xff" + register "hwm_fan1_seg2_speed_count" = "0x0e" + register "hwm_fan1_seg3_speed_count" = "0x07" + register "hwm_fan1_temp_map_sel" = "0x8c" +# # XXX: 4e is the default index port and .xy is the # LDN indexing the pnp_info array found in the superio.c # NB: Jetway board changes the default (0x4e) index port to (0x2e) by pin 124, diff --git a/src/superio/fintek/f71869ad/Makefile.inc b/src/superio/fintek/f71869ad/Makefile.inc index 87d96e4..1d8cc6a 100644 --- a/src/superio/fintek/f71869ad/Makefile.inc +++ b/src/superio/fintek/f71869ad/Makefile.inc @@ -19,4 +19,5 @@ ##
ramstage-$(CONFIG_SUPERIO_FINTEK_F71869AD) += f71869ad_multifunc.c +ramstage-$(CONFIG_SUPERIO_FINTEK_F71869AD) += f71869ad_hwm.c ramstage-$(CONFIG_SUPERIO_FINTEK_F71869AD) += superio.c diff --git a/src/superio/fintek/f71869ad/chip.h b/src/superio/fintek/f71869ad/chip.h index 5011383..ddad589 100644 --- a/src/superio/fintek/f71869ad/chip.h +++ b/src/superio/fintek/f71869ad/chip.h @@ -33,6 +33,17 @@ struct superio_fintek_f71869ad_config { uint8_t multi_function_register_3; uint8_t multi_function_register_4; uint8_t multi_function_register_5; + /* HWM configuration registers */ + uint8_t hwm_smbus_address; + uint8_t hwm_smbus_control_reg; + uint8_t hwm_fan_type_sel_reg; + uint8_t hwm_fan1_temp_adj_rate_reg; + uint8_t hwm_fan_mode_sel_reg; + uint8_t hwm_fan1_idx_rpm_mode; + uint8_t hwm_fan1_seg1_speed_count; + uint8_t hwm_fan1_seg2_speed_count; + uint8_t hwm_fan1_seg3_speed_count; + uint8_t hwm_fan1_temp_map_sel; };
#endif /* SUPERIO_FINTEK_F71869AD_CHIP_H */ diff --git a/src/superio/fintek/f71869ad/f71869ad_hwm.c b/src/superio/fintek/f71869ad/f71869ad_hwm.c new file mode 100644 index 0000000..f048299 --- /dev/null +++ b/src/superio/fintek/f71869ad/f71869ad_hwm.c @@ -0,0 +1,112 @@ +/* + * This file is part of the coreboot project. + * + * Copyright (C) 2014 Edward O'Callaghan eocallaghan@alterapraxis.com + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2 of the License, or + * (at your option) any later version. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software + * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA + */ + +#include <arch/io.h> +#include <console/console.h> +#include <device/device.h> +#include <device/pnp.h> +#include "chip.h" +#include "fintek_internal.h" + +/* + * The Fintek F71869AD Super I/O Hardware Monitor permits the configuration of + * three fans individually, where fan1 is typically taken as the CPU fan. Each + * fan is controlled by the relation: + * + * Tfan? = Tnow + (Ta - Tb)*Ct + * + * Parameters in this relation are specified in the devicetree.cb. + */ + +/* + * Register CR01 ~ CR03 -> Configuration Registers + * Register CR0A ~ CR0F -> PECI/TSI Control Register + * Register CR10 ~ CR37 -> Voltage Setting Register + * Register CR40 ~ CR4E -> PECI 3.0 Command and Register + * Register CR60 ~ CR8E -> Temperature Setting Register + * Register CR90 ~ CRDF -> Fan Control Setting Register + */ +#define HWM_SMBUS_ADDR 0x08 +#define HWM_SMBUS_CONTROL_REG 0x0A +#define HWM_FAN_TYPE_SEL_REG 0x94 +#define HWM_FAN1_TEMP_ADJ_RATE_REG 0x95 +#define HWM_FAN_MODE_SEL_REG 0x96 +#define HWM_FAN_FAULT_TIME_REG 0x9F /* bit7 FAN_PROG_SEL */ +#define HWM_FAN1_IDX_RPM_MODE 0xA3 +#define HWM_FAN1_SEG1_SPEED_COUNT 0xAA +#define HWM_FAN1_SEG2_SPEED_COUNT 0xAB +#define HWM_FAN1_SEG3_SPEED_COUNT 0xAC +#define HWM_FAN1_TEMP_MAP_SEL 0xAF + +static void pnp_write_index(u16 port, u8 reg, u8 value) +{ + outb(reg, port); + outb(value, port + 1); +} + +/* note: multifunc registers need to be tweaked before here */ +void f71869ad_hwm_init(device_t dev) +{ + struct superio_fintek_f71869ad_config *conf = dev->chip_info; + struct resource *res = find_resource(dev, PNP_IDX_IO0); + + if (!res) { + printk(BIOS_WARNING, "Super I/O HWM: No HWM resource found.\n"); + return; + } + u16 port = res->base; /* data-sheet default base = 0x229 */ + + printk(BIOS_INFO, + "Fintek F71869AD Super I/O HWM: Initializing Hardware Monitor..\n"); + printk(BIOS_DEBUG, + "Fintek F71869AD Super I/O HWM: Base Address at 0x%x\n", port); + + pnp_enter_conf_mode(dev); + pnp_set_logical_device(dev); + + /* Fintek F71869AD HWM (ordered) programming sequence. */ + + /* SMBus Address p.53 */ + pnp_write_index(port, HWM_SMBUS_ADDR, conf->hwm_smbus_address); + /* Configure pins 57/58 as PECI_REQ#/PECI (AMD_TSI) p.54 */ + pnp_write_index(port, HWM_SMBUS_CONTROL_REG, conf->hwm_smbus_control_reg); + /* Tfan1 = Tnow + (Ta - Tb)*Ct where, */ + /* FAN1_TEMP_SEL_DIG, FAN1_TEMP_SEL (Tnow) set to come from CR7Ah p.73 */ + pnp_write_index(port, HWM_FAN1_TEMP_MAP_SEL, conf->hwm_fan1_temp_map_sel); + /* set FAN_PROG_SEL = 1 */ + pnp_write_index(port, HWM_FAN_FAULT_TIME_REG, 0x8a); + /* FAN1_BASE_TEMP (Tb) set when FAN_PROG_SEL=1, p.64-65 */ + pnp_write_index(port, HWM_FAN_TYPE_SEL_REG, conf->hwm_fan_type_sel_reg); + /* set TFAN1_ADJ_SEL (Ta) p.67 to use CR7Ah p.61 */ + pnp_write_index(port, HWM_FAN_MODE_SEL_REG, conf->hwm_fan_mode_sel_reg); + /* TFAN1_ADJ_{UP,DOWN}_RATE (Ct=1/4 up & down) in 0x95 when FAN_PROG_SEL = + 1, p.88 */ + pnp_write_index(port, HWM_FAN1_TEMP_ADJ_RATE_REG, conf->hwm_fan1_temp_adj_rate_reg); + /* set FAN_PROG_SEL = 0 */ + pnp_write_index(port, HWM_FAN_FAULT_TIME_REG, 0x0a); + /* FAN1 RPM mode p.70 */ + pnp_write_index(port, HWM_FAN1_IDX_RPM_MODE, conf->hwm_fan1_idx_rpm_mode); + /* FAN1 Segment X Speed Count */ + pnp_write_index(port, HWM_FAN1_SEG1_SPEED_COUNT, conf->hwm_fan1_seg1_speed_count); + pnp_write_index(port, HWM_FAN1_SEG2_SPEED_COUNT, conf->hwm_fan1_seg2_speed_count); + pnp_write_index(port, HWM_FAN1_SEG3_SPEED_COUNT, conf->hwm_fan1_seg3_speed_count); + + pnp_exit_conf_mode(dev); +} diff --git a/src/superio/fintek/f71869ad/fintek_internal.h b/src/superio/fintek/f71869ad/fintek_internal.h index 86f5669..6856c01 100644 --- a/src/superio/fintek/f71869ad/fintek_internal.h +++ b/src/superio/fintek/f71869ad/fintek_internal.h @@ -25,5 +25,6 @@ #include <device/pnp.h>
void f71869ad_multifunc_init(device_t dev); +void f71869ad_hwm_init(device_t dev);
#endif /* SUPERIO_FINTEK_F71869AD_INTERNAL_H */ diff --git a/src/superio/fintek/f71869ad/superio.c b/src/superio/fintek/f71869ad/superio.c index 770a712..cc690ec 100644 --- a/src/superio/fintek/f71869ad/superio.c +++ b/src/superio/fintek/f71869ad/superio.c @@ -43,6 +43,7 @@ static void f71869ad_init(device_t dev) break; case F71869AD_HWM: f71869ad_multifunc_init(dev); + f71869ad_hwm_init(dev); break; } }