[coreboot-gerrit] Change in coreboot[master]: mb/google/dedede: Enable trackpad support

[Varshit B Pandya (Code Review)]

Varshit B Pandya has uploaded this change for review. ( https://review.coreboot.org/c/coreboot/+/39236 )

Change subject: mb/google/dedede: Enable trackpad support
......................................................................

mb/google/dedede: Enable trackpad support

1. Configure trackpad interrupt GPIO.
2. Set i2c0 configuration.
3. Add trackpad ACPI support.

Signed-off-by: Pandya, Varshit B 
Change-Id: I52c578aef591f5be90fb709bab4c8342ea9729e6
---
M src/mainboard/google/dedede/variants/baseboard/gpio.c
M src/mainboard/google/dedede/variants/waddledoo/overridetree.cb
2 files changed, 51 insertions(+), 1 deletion(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/36/39236/1

diff --git a/src/mainboard/google/dedede/variants/baseboard/gpio.c b/src/mainboard/google/dedede/variants/baseboard/gpio.c
index f4fcd8d..2b93159 100644
--- a/src/mainboard/google/dedede/variants/baseboard/gpio.c
+++ b/src/mainboard/google/dedede/variants/baseboard/gpio.c
@@ -55,7 +55,7 @@
    /* B2  : PROCHOT_ODL */
    PAD_NC(GPP_B2, NONE),
    /* B3  : TRACKPAD_INT_ODL */
-	PAD_NC(GPP_B3, NONE),
+	PAD_CFG_GPI_APIC(GPP_B3, NONE, PLTRST, EDGE_SINGLE, INVERT),
    /* B4  : H1_PCH_INT_ODL */
    PAD_CFG_GPI_APIC(GPP_B4, NONE, PLTRST, LEVEL, INVERT),
    /* B5  : PCIE_CLKREQ0_N */
diff --git a/src/mainboard/google/dedede/variants/waddledoo/overridetree.cb b/src/mainboard/google/dedede/variants/waddledoo/overridetree.cb
index 1a61143..9694d1a 100644
--- a/src/mainboard/google/dedede/variants/waddledoo/overridetree.cb
+++ b/src/mainboard/google/dedede/variants/waddledoo/overridetree.cb
@@ -1,5 +1,55 @@
 chip soc/intel/tigerlake
+	device domain 0 on end
+
+	# Intel Common SoC Config
+	#+-------------------+---------------------------+
+	#| Field             |  Value                    |
+	#+-------------------+---------------------------+
+	#| GSPI0             | cr50 TPM. Early init is   |
+	#|                   | required to set up a BAR  |
+	#|                   | for TPM communication     |
+	#|                   | before memory is up       |
+	#| I2C0              | Trackpad                  |
+	#| I2C1              | Digitizer                 |
+	#| I2C2              | Touchscreen               |
+	#| I2C3              | Camera                    |
+	#| I2C4              | Audio                     |
+	#+-------------------+---------------------------+
+	register "common_soc_config" = "{
+		.gspi[0] = {
+			.speed_mhz = 1,
+			.early_init = 1,
+		},
+		.i2c[0] = {
+			.speed = I2C_SPEED_FAST,
+			.rise_time_ns = 66,
+			.fall_time_ns = 90,
+			.data_hold_time_ns = 350,
+		},
+		.i2c[1] = {
+			.speed = I2C_SPEED_FAST,
+		},
+		.i2c[2] = {
+			.speed = I2C_SPEED_FAST,
+		},
+		.i2c[3] = {
+			.speed = I2C_SPEED_FAST,
+		},
+		.i2c[4] = {
+			.speed = I2C_SPEED_FAST,
+		},
+	}"
    device domain 0 on
+		device pci 15.0 on
+			chip drivers/i2c/generic
+				register "hid" = ""ELAN0000""
+				register "desc" = ""ELAN Touchpad""
+				register "irq" = "ACPI_IRQ_WAKE_EDGE_LOW(GPP_B3_IRQ)"
+				register "wake" = "GPE0_DW0_03"
+				register "probed" = "1"
+				device i2c 15 on end
+			end
+		end #I2C 0
    	device pci 1c.7 on
    		chip drivers/intel/wifi
    			register "wake" = "GPE0_DW2_03"