Patrick Georgi has submitted this change and it was merged. ( https://review.coreboot.org/c/coreboot/+/31125 )
Change subject: siemens/mc_apl2: Activate TPM support ......................................................................
siemens/mc_apl2: Activate TPM support
The TPM chip is connected to the SPI interface of APL. The proper chip select pin needs to be used in order to access the TPM in the memory mapped space. This needed chip select is internally (inside APL) routable to GPIO 106. Therefore the change of GPIO 106 mode is needed to make the TPM work on SPI bus.
TEST=Build coreboot for mc_apl2 board and check the TPM console output. In addition the TPM was correctly verified by our Linux driver.
Change-Id: I2b0d5a6f2c230187857c2428a70de61f21da6724 Signed-off-by: Mario Scheithauer mario.scheithauer@siemens.com Reviewed-on: https://review.coreboot.org/c/31125 Tested-by: build bot (Jenkins) no-reply@coreboot.org Reviewed-by: Nico Huber nico.h@gmx.de --- M src/mainboard/siemens/mc_apl1/variants/mc_apl2/Kconfig M src/mainboard/siemens/mc_apl1/variants/mc_apl2/devicetree.cb M src/mainboard/siemens/mc_apl1/variants/mc_apl2/gpio.c 3 files changed, 10 insertions(+), 2 deletions(-)
Approvals: build bot (Jenkins): Verified Nico Huber: Looks good to me, approved
diff --git a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/Kconfig b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/Kconfig index 393f9c6..4e4a928 100644 --- a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/Kconfig +++ b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/Kconfig @@ -6,5 +6,8 @@ select DRIVER_INTEL_I210 select DRIVERS_I2C_RX6110SA select DRIVER_SIEMENS_NC_FPGA + select MAINBOARD_HAS_TPM2 + select MAINBOARD_HAS_LPC_TPM + select TPM_ON_FAST_SPI
endif # BOARD_SIEMENS_MC_APL2 diff --git a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/devicetree.cb b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/devicetree.cb index 42c4310..d2d5394 100644 --- a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/devicetree.cb +++ b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/devicetree.cb @@ -104,6 +104,11 @@ device pci 1d.0 off end # - UFS device pci 1e.0 off end # - SDIO device pci 1f.0 on end # - LPC + device pci 1f.0 on # - LPC + chip drivers/pc80/tpm + device pnp 0c31.0 on end + end + end device pci 1f.1 on end # - SMBUS end end diff --git a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/gpio.c b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/gpio.c index a54dae5..d1ca679 100644 --- a/src/mainboard/siemens/mc_apl1/variants/mc_apl2/gpio.c +++ b/src/mainboard/siemens/mc_apl1/variants/mc_apl2/gpio.c @@ -363,8 +363,8 @@ PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_104, DN_20K, DEEP, NF1, HIZCRx0, ENPD), /* SIO_SPI_FS0_1V8 - Connected to ESPI_CS0# of SMARC connector. */ PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_105, DN_20K, DEEP, NF1, HIZCRx0, ENPD), - /* SIO_SPI_FS1_1V8 - Connected to ESPI_CS1# of SMARC connector. */ - PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_106, UP_20K, DEEP, NF1, HIZCRx0, ENPD), + /* SIO_SPI_FS1_1V8 - Connected to FST_SPI_CS2_N of SMARC connector. */ + PAD_CFG_NF(GPIO_106, NATIVE, DEEP, NF3), /* SIO_SPI_MISO_1V8 - Connected to ESPI_IO_0 of SMARC connector. */ PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_109, DN_20K, DEEP, NF1, HIZCRx0, ENPD), /* SIO_SPI_MOSI_1V8 - Connected to ESPI_IO_1 of SMARC connector. */