Patch set updated for coreboot: 1a1b1cb exynos5420: ddr3: Switch from 4G setup to 2G setup on exynos5420

[Isaac Christensen]

Isaac Christensen ([e-mail]) just uploaded a new patch set to gerrit, which you can find at http://review.coreboot.org/6612

-gerrit

commit 1a1b1cb890d171dda759c97f9de6d49f03f85a59
Author: David Hendricks 
Date:   Fri Aug 23 15:25:07 2013 -0700

exynos5420: ddr3: Switch from 4G setup to 2G setup on exynos5420

This changes the number of chip selects that we configure from 2 to 1.
    On current setups with (x16 memory 4Gbit chips) that means that we're
    at 2GByte.

Technically we should add a second setting in the ares_ddr3_timings
    and select between the two of the based on board strappings.  That
    would make the CONFIG_RUN_TIME_BANK_NUMBER work properly.  I've
    changed the ddr3_mem_ctrl_init() so it should handle that, but I'm not
    actually doing the board strapping read right now.

This change means that accesses to 0xA0000000 - 0xFFFFFFFF on 2G
    systems will no longer put the system in a messed up state (leading to
    a hang).  It also prevents some of the weird boot behavior that we've
    seen that comes and goes depending on U-Boot alignment.  See
    http://crosbug.com/p/20577.

This patch was ported from: https://gerrit.chromium.org/gerrit/66117
    Signed-off-by: David Hendricks

Change-Id: Ib4cfe420aac30bd817438f06d01e8671afc4a27d
    Reviewed-on: https://chromium-review.googlesource.com/167210
    Commit-Queue: David Hendricks 
    Tested-by: David Hendricks 
    Reviewed-by: ron minnich 
    (cherry picked from commit 0ea574243058068702e3f6bc7355098745d16880)
    Signed-off-by: Isaac Christensen 
---
 src/cpu/samsung/exynos5420/dmc_init_ddr3.c | 36 +++++++++++++++++-------------
 src/mainboard/google/pit/memory.c          |  6 ++---
 2 files changed, 24 insertions(+), 18 deletions(-)

diff --git a/src/cpu/samsung/exynos5420/dmc_init_ddr3.c b/src/cpu/samsung/exynos5420/dmc_init_ddr3.c
index a758433..1126dca 100644
--- a/src/cpu/samsung/exynos5420/dmc_init_ddr3.c
+++ b/src/cpu/samsung/exynos5420/dmc_init_ddr3.c
@@ -44,7 +44,7 @@ int ddr3_mem_ctrl_init(struct mem_timings *mem, int interleave_size, int reset)
    struct exynos5_dmc *drex0, *drex1;
    struct exynos5_tzasc *tzasc0, *tzasc1;
    u32 val, nLockR, nLockW_phy0, nLockW_phy1;
-	int i;
+	int i, chip;

phy0_ctrl = (struct exynos5_phy_control *)EXYNOS5_DMC_PHY0_BASE;
    phy1_ctrl = (struct exynos5_phy_control *)EXYNOS5_DMC_PHY1_BASE;
@@ -218,12 +218,14 @@ int ddr3_mem_ctrl_init(struct mem_timings *mem, int interleave_size, int reset)
    	 * Send auto refresh command for DRAM refresh.
    	 */
    	for (i = 0; i < 128; i++) {
-			writel(DIRECT_CMD_REFA, &drex0->directcmd);
-			writel(DIRECT_CMD_REFA | (0x1 << DIRECT_CMD_CHIP_SHIFT),
-				&drex0->directcmd);
-			writel(DIRECT_CMD_REFA, &drex1->directcmd);
-			writel(DIRECT_CMD_REFA | (0x1 << DIRECT_CMD_CHIP_SHIFT),
-				&drex1->directcmd);
+			for (chip = 0; chip < mem->chips_to_configure; chip++) {
+				writel(DIRECT_CMD_REFA |
+					(chip << DIRECT_CMD_CHIP_SHIFT),
+					&drex0->directcmd);
+				writel(DIRECT_CMD_REFA |
+					(chip << DIRECT_CMD_CHIP_SHIFT),
+					&drex1->directcmd);
+			}
    	}
    }

@@ -263,10 +265,12 @@ int ddr3_mem_ctrl_init(struct mem_timings *mem, int interleave_size, int reset)
    	writel(nLockR, &phy1_ctrl->phy_con12);

val = (0x3 << DIRECT_CMD_BANK_SHIFT) | 0x4;
-		writel(val, &drex0->directcmd);
-		writel(val | (0x1 << DIRECT_CMD_CHIP_SHIFT), &drex0->directcmd);
-		writel(val, &drex1->directcmd);
-		writel(val | (0x1 << DIRECT_CMD_CHIP_SHIFT), &drex1->directcmd);
+		for (chip = 0; chip < mem->chips_to_configure; chip++) {
+			writel(val | (chip << DIRECT_CMD_CHIP_SHIFT),
+				&drex0->directcmd);
+			writel(val | (chip << DIRECT_CMD_CHIP_SHIFT),
+				&drex1->directcmd);
+		}

setbits_le32(&phy0_ctrl->phy_con2, RDLVL_GATE_EN);
    	setbits_le32(&phy1_ctrl->phy_con2, RDLVL_GATE_EN);
@@ -316,10 +320,12 @@ int ddr3_mem_ctrl_init(struct mem_timings *mem, int interleave_size, int reset)
    	writel(0, &phy1_ctrl->phy_con14);

val = (0x3 << DIRECT_CMD_BANK_SHIFT);
-		writel(val, &drex0->directcmd);
-		writel(val | (0x1 << DIRECT_CMD_CHIP_SHIFT), &drex0->directcmd);
-		writel(val, &drex1->directcmd);
-		writel(val | (0x1 << DIRECT_CMD_CHIP_SHIFT), &drex1->directcmd);
+		for (chip = 0; chip < mem->chips_to_configure; chip++) {
+			writel(val | (chip << DIRECT_CMD_CHIP_SHIFT),
+				&drex0->directcmd);
+			writel(val | (chip << DIRECT_CMD_CHIP_SHIFT),
+				&drex1->directcmd);
+		}

/* Common Settings for Leveling */
    	val = PHY_CON12_RESET_VAL;
diff --git a/src/mainboard/google/pit/memory.c b/src/mainboard/google/pit/memory.c
index ddd7aa0..4ac3d0c 100644
--- a/src/mainboard/google/pit/memory.c
+++ b/src/mainboard/google/pit/memory.c
@@ -86,7 +86,7 @@ const struct mem_timings mem_timings = {
    		DMC_MEMCONTROL_ADD_LAT_PALL_CYCLE(0) |
    		DMC_MEMCONTROL_MEM_TYPE_DDR3 |
    		DMC_MEMCONTROL_MEM_WIDTH_32BIT |
-			DMC_MEMCONTROL_NUM_CHIP_2 |
+			DMC_MEMCONTROL_NUM_CHIP_1 |
    		DMC_MEMCONTROL_BL_8 |
    		DMC_MEMCONTROL_PZQ_DISABLE |
    		DMC_MEMCONTROL_MRR_BYTE_7_0,
@@ -104,8 +104,8 @@ const struct mem_timings mem_timings = {
    		DMC_CONCONTROL_AREF_EN_DISABLE |
    		DMC_CONCONTROL_IO_PD_CON_DISABLE,
    	.dmc_channels = 1,
-		.chips_per_channel = 2,
-		.chips_to_configure = 2,
+		.chips_per_channel = 1,
+		.chips_to_configure = 1,
    	.send_zq_init = 1,
    	.gate_leveling_enable = 1,
 };