[M] Change in coreboot[main]: soc/xilinx/zynq7000: Initial Xilinx Zynq 7000 SoC bringup

[Nicholas Chin (Code Review)]

Nicholas Chin has uploaded this change for review. ( https://review.coreboot.org/c/coreboot/+/84343?usp=email )

Change subject: soc/xilinx/zynq7000: Initial Xilinx Zynq 7000 SoC bringup
......................................................................

soc/xilinx/zynq7000: Initial Xilinx Zynq 7000 SoC bringup

The Zynq 7000 family of SoCs integrates up to two Cortex-A9 processor
cores with FPGA fabric using Xilinx's 7-series architecture. This commit
adds the bare minimum support code to compile a rom successfully when
the SoC is selected by a board. This code was loosely based on the TI
AM335x code, especially the memlayout.ld file.

In its current state valid Zynq boot images cannot be produced. CBFS
media is not yet supported so only the bootblock is able to run. The
easiest way to run this code is to manually load the bootblock ELF into
memory over JTAG using OpenOCD.

Change-Id: I45aa4e3a11074fa447d4008ac3c96d44f891831c
Signed-off-by: Nicholas Chin 
---
A src/soc/xilinx/Kconfig
A src/soc/xilinx/zynq7000/Kconfig
A src/soc/xilinx/zynq7000/Makefile.mk
A src/soc/xilinx/zynq7000/cbmem.c
A src/soc/xilinx/zynq7000/memlayout.ld
A src/soc/xilinx/zynq7000/reset.c
A src/soc/xilinx/zynq7000/soc.c
A src/soc/xilinx/zynq7000/timer.c
8 files changed, 135 insertions(+), 0 deletions(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/43/84343/1

diff --git a/src/soc/xilinx/Kconfig b/src/soc/xilinx/Kconfig
new file mode 100644
index 0000000..95100a0
--- /dev/null
+++ b/src/soc/xilinx/Kconfig
@@ -0,0 +1,4 @@
+## SPDX-License-Identifier: GPL-2.0-only
+
+# Load all chipsets
+source "src/soc/xilinx/*/Kconfig"
diff --git a/src/soc/xilinx/zynq7000/Kconfig b/src/soc/xilinx/zynq7000/Kconfig
new file mode 100644
index 0000000..3254435
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/Kconfig
@@ -0,0 +1,17 @@
+## SPDX-License-Identifier: GPL-2.0-only
+#
+config SOC_XILINX_ZYNQ7000
+	bool
+	default n
+	select ARCH_BOOTBLOCK_ARMV7
+	select ARCH_VERSTAGE_ARMV7
+	select ARCH_ROMSTAGE_ARMV7
+	select ARCH_RAMSTAGE_ARMV7
+
+if SOC_XILINX_ZYNQ7000
+
+config MEMLAYOUT_LD_FILE
+	string
+	default "src/soc/xilinx/zynq7000/memlayout.ld"
+
+endif
diff --git a/src/soc/xilinx/zynq7000/Makefile.mk b/src/soc/xilinx/zynq7000/Makefile.mk
new file mode 100644
index 0000000..b6b4e1c
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/Makefile.mk
@@ -0,0 +1,15 @@
+# SPDX-License-Identifier: GPL-2.0-only
+ifeq ($(CONFIG_SOC_XILINX_ZYNQ7000),y)
+
+bootblock-y += timer.c
+romstage-y += timer.c
+ramstage-y += timer.c
+
+romstage-y += cbmem.c
+ramstage-y += soc.c
+
+bootblock-y += reset.c
+romstage-y += reset.c
+ramstage-y += reset.c
+
+endif
diff --git a/src/soc/xilinx/zynq7000/cbmem.c b/src/soc/xilinx/zynq7000/cbmem.c
new file mode 100644
index 0000000..eb0f0f4
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/cbmem.c
@@ -0,0 +1,9 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+
+#include <cbmem.h>
+#include <commonlib/bsd/helpers.h>
+
+uintptr_t cbmem_top_chipset(void)
+{
+	return CONFIG_DRAM_SIZE_MB * MiB;
+}
diff --git a/src/soc/xilinx/zynq7000/memlayout.ld b/src/soc/xilinx/zynq7000/memlayout.ld
new file mode 100644
index 0000000..1ebd0d8
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/memlayout.ld
@@ -0,0 +1,24 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+
+#include <memlayout.h>
+
+#include <arch/header.ld>
+
+SECTIONS
+{
+	SRAM_START(0x00000000)
+	BOOTBLOCK(0x00000000, 20K)
+	FMAP_CACHE(0x00000000+20K, 2K)
+	CBFS_MCACHE(0x00000000+20K+2K, 8K)
+	TTB(0x00008000, 16K)
+	ROMSTAGE(0x00008000+16K, 40K)
+
+	PRERAM_CBFS_CACHE(0x00008000+16K+40K, 20K)
+
+	STACK(0x0001b000, 4K)
+	SRAM_END(0x30000)
+
+	DRAM_START(0x100000)
+	RAMSTAGE(0x100000, 2M)
+	POSTRAM_CBFS_CACHE(0x300000, 32M)
+}
diff --git a/src/soc/xilinx/zynq7000/reset.c b/src/soc/xilinx/zynq7000/reset.c
new file mode 100644
index 0000000..339acb6
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/reset.c
@@ -0,0 +1,13 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+
+#include <device/mmio.h>
+#include <reset.h>
+
+#define SLCR_UNLOCK ((void *)0xF8000008u)
+#define SLCR_UNLOCK_KEY 0xDF0D
+#define PSS_RST_CTRL ((void *)0xF8000200u)
+void do_board_reset(void)
+{
+	write16(SLCR_UNLOCK, SLCR_UNLOCK_KEY);
+	write32(PSS_RST_CTRL, 1);
+}
diff --git a/src/soc/xilinx/zynq7000/soc.c b/src/soc/xilinx/zynq7000/soc.c
new file mode 100644
index 0000000..987e437
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/soc.c
@@ -0,0 +1,15 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+
+#include <bootmem.h>
+#include <device/device.h>
+#include <symbols.h>
+
+static void soc_enable(struct device *dev)
+{
+	ram_range(dev, 0, 0, CONFIG_DRAM_SIZE_MB * (uint64_t)MiB);
+}
+
+struct chip_operations soc_xilinx_zynq7000_ops = {
+	.name = "Xilinx Zynq 7000",
+	.enable_dev = soc_enable,
+};
diff --git a/src/soc/xilinx/zynq7000/timer.c b/src/soc/xilinx/zynq7000/timer.c
new file mode 100644
index 0000000..0448aa6
--- /dev/null
+++ b/src/soc/xilinx/zynq7000/timer.c
@@ -0,0 +1,38 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+
+#include <timer.h>
+#include <delay.h>
+#include <device/mmio.h>
+#include <stdint.h>
+
+#define G_TIMER_COUNTER_0 ((void *)0xF8F00200u)
+#define G_TIMER_COUNTER_1 ((void *)0xF8F00204u)
+#define G_TIMER_CTRL ((void *)0xF8F00208u)
+
+#define CLK_PER_USEC 108
+
+static inline uint64_t timer_raw_value(void)
+{
+	uint32_t upper, lower;
+	do {
+		upper = read32(G_TIMER_COUNTER_1);
+		lower = read32(G_TIMER_COUNTER_0);
+	} while (upper != read32(G_TIMER_COUNTER_1));
+
+	return (((uint64_t)upper) << 32) | lower;
+}
+
+void init_timer(void)
+{
+	/* Disable timer */
+	write32(G_TIMER_CTRL, read32(G_TIMER_CTRL) & ~0x1);
+	write32(G_TIMER_COUNTER_0, 0);
+	write32(G_TIMER_COUNTER_1, 0);
+	/* Enable timer */
+	write32(G_TIMER_CTRL, read32(G_TIMER_CTRL) | 0x1);
+}
+
+void timer_monotonic_get(struct mono_time *mt)
+{
+	mono_time_set_usecs(mt, timer_raw_value() / CLK_PER_USEC);
+}