[coreboot-gerrit] Change in coreboot[master]: sc7180: Renaming the GPIO macro in QSPI and I2C driver

[Ravi kumar (Code Review)]

Ravi kumar has uploaded this change for review. ( https://review.coreboot.org/c/coreboot/+/56194 )

Change subject: sc7180: Renaming the GPIO macro in QSPI and I2C driver
......................................................................

sc7180: Renaming the GPIO macro in QSPI and I2C driver

As part of GPIO driver cleanup across qcom chipsets,
GPIO_OUTPUT_ENABLE has been renamed to GPIO_OUTPUT.

BUG=b:182963902
TEST=Validated on qualcomm sc7180 development board

Signed-off-by: Rajesh Patil 
Change-Id: I51eedc722a91c5ea8e009fb8468a60667d374b49
---
M src/soc/qualcomm/sc7180/qspi.c
M src/soc/qualcomm/sc7180/qupv3_i2c.c
2 files changed, 5 insertions(+), 5 deletions(-)

git pull ssh://review.coreboot.org:29418/coreboot refs/changes/94/56194/1

diff --git a/src/soc/qualcomm/sc7180/qspi.c b/src/soc/qualcomm/sc7180/qspi.c
index c1e9779..825e298 100644
--- a/src/soc/qualcomm/sc7180/qspi.c
+++ b/src/soc/qualcomm/sc7180/qspi.c
@@ -146,13 +146,13 @@
    gpio_output(GPIO(68), 1);

gpio_configure(GPIO(64), GPIO64_FUNC_QSPI_DATA_0,
-		GPIO_NO_PULL, GPIO_2MA, GPIO_OUTPUT_ENABLE);
+		GPIO_NO_PULL, GPIO_2MA, GPIO_OUTPUT);

gpio_configure(GPIO(65), GPIO65_FUNC_QSPI_DATA_1,
-		GPIO_NO_PULL, GPIO_2MA, GPIO_OUTPUT_ENABLE);
+		GPIO_NO_PULL, GPIO_2MA, GPIO_OUTPUT);

gpio_configure(GPIO(63), GPIO63_FUNC_QSPI_CLK,
-		GPIO_NO_PULL, GPIO_8MA, GPIO_OUTPUT_ENABLE);
+		GPIO_NO_PULL, GPIO_8MA, GPIO_OUTPUT);
 }

static void queue_bounce_data(uint8_t *data, uint32_t data_bytes,
diff --git a/src/soc/qualcomm/sc7180/qupv3_i2c.c b/src/soc/qualcomm/sc7180/qupv3_i2c.c
index c9adba4..5dc4d31 100644
--- a/src/soc/qualcomm/sc7180/qupv3_i2c.c
+++ b/src/soc/qualcomm/sc7180/qupv3_i2c.c
@@ -92,9 +92,9 @@

/* GPIO Configuration */
    gpio_configure(qup[bus].pin[0], qup[bus].func[0], GPIO_PULL_UP,
-				GPIO_2MA, GPIO_OUTPUT_ENABLE);
+				GPIO_2MA, GPIO_OUTPUT);
    gpio_configure(qup[bus].pin[1], qup[bus].func[1], GPIO_PULL_UP,
-				GPIO_2MA, GPIO_OUTPUT_ENABLE);
+				GPIO_2MA, GPIO_OUTPUT);

/* Select and setup FIFO mode */
    write32(&regs->geni_m_irq_clear, 0xFFFFFFFF);