Attention is currently required from: Angel Pons. Hello Felix Singer, build bot (Jenkins), Nico Huber, Angel Pons,
I'd like you to reexamine a change. Please visit
https://review.coreboot.org/c/coreboot/+/54380
to look at the new patch set (#11).
Change subject: kontron/mal10: Set up GPIOs in CPLD/EC ......................................................................
kontron/mal10: Set up GPIOs in CPLD/EC
The COMe module connector implements 8 GPIO lines from the CPLD/EC pins. Use the Kempld GPIO driver[1] to configure these pins in accordance with the COM Express Module Base Specification [2].
TEST = Set different logic states for the pin configured as outputs and check them with an oscilloscope.
[1] CB:47595 , Change-Id: Id767aa451fbf2ca1c0dccfc9aa2c024c6f37c1bb [2] page 79-81, PICMG (R) COM.0 Revision 3.0 COM Express (R) Base Specification - March 31, 2017.
Change-Id: I7d354aa32ac8c64f54b2bcbdb4f1b8915f55264e Signed-off-by: Maxim Polyakov max.senia.poliak@gmail.com --- M src/mainboard/kontron/mal10/variants/mal10/devicetree.cb 1 file changed, 11 insertions(+), 0 deletions(-)
git pull ssh://review.coreboot.org:29418/coreboot refs/changes/80/54380/11