Daniel H Kang has uploaded a new patch set (#3) to the change originally created by Daniel Kang. ( https://review.coreboot.org/c/coreboot/+/45058 )
Change subject: mb/google/volteer: Change default camera power GPIO to 0 ......................................................................
mb/google/volteer: Change default camera power GPIO to 0
The default GPIO values for camera power were set as 1 so the LED was turned on by default when the board is powered on. This status is kept until the camera is probed then being turned off. So the LED is turned on for a few seconds during the boot up.
By setting the default power to 0, the LED is lit only when camera is turned on for probing and this should be a just blink.
BUG=b:167635396 BRANCH=none TEST=Build and boot volteer board. Monitor camera privacy LED and check it is not lit more than 0.5 seconds.
Signed-off-by: Daniel Kang daniel.h.kang@intel.com Change-Id: Ic7df391aa512daafe6e1ce49e9222b90e17ad806 --- M src/mainboard/google/volteer/variants/volteer/gpio.c M src/mainboard/google/volteer/variants/volteer2/gpio.c 2 files changed, 8 insertions(+), 8 deletions(-)
git pull ssh://review.coreboot.org:29418/coreboot refs/changes/58/45058/3