[S] Change in flashrom[main]: buspirate_spi: Add support for hiz output with pullups=off

[David Reguera Garcia (Code Review)]

Attention is currently required from: Anastasia Klimchuk, Thomas Heijligen.

Hello Anastasia Klimchuk, Thomas Heijligen, build bot (Jenkins),

I'd like you to reexamine a change. Please visit

https://review.coreboot.org/c/flashrom/+/79299?usp=email

to look at the new patch set (#6).

Change subject: buspirate_spi: Add support for hiz output with pullups=off
......................................................................

buspirate_spi: Add support for hiz output with pullups=off

When working with low-voltage chips, the internal 10k pull-ups of the Bus Pirate might be too high. In such cases, it's necessary to create an external pull-up using lower-value resistors. For this, you can use the 'hiz' parameter.  This way, the Bus Pirate will operate as an open drain with 'pullups=off'

So, why not just use the 'pullups=on' option for this scenario? I'm trying to prevent a very typical human error in the training sessions I conduct. For example, in the previous session, a user might have left the VPU (vextern) connected to 5V, and now they need to access a 1.8V chip. If 'pullups=on' is used, the following will happen: 5V (VPU) --> CD4060 --> 2K (internal Bus Pirate) --> MOSI target chip. By having the option to set a 'hiz=on', this can be avoided. Since the pull-ups will remain deactivated while the Bus Pirate will function in an open-drain mode

Change-Id: I6d9909b23782ef3fcb1428fd127dae0d6b211855
Signed-off-by: David Reguera Garcia 
---
M buspirate_spi.c
M doc/classic_cli_manpage.rst
2 files changed, 22 insertions(+), 2 deletions(-)

git pull ssh://review.coreboot.org:29418/flashrom refs/changes/99/79299/6