Erase faild

[Marco Runge]

Hi,

I am a Software Engineer from Raytheon Anschütz Germany and wanted to use 
flashrom to update the bios of our embedded bord form emerson. 
Unfortuneately s.th. must have gone wrong. First write of the bios was 
fine but after reboot I got a crisis report that the two flash banks are 
corrupt. I could boot from thumb drive anyway and wanted to write the 
backup copy but got the following error message:

Erase failed at 0x00000010! Expected=0xff, Read=0x5a, failed byte count 
from 0x00000000 - 0x0000ffff: 0xd092.

We are using the following board: 
http://www.emersonnetworkpower.com/en-US/Products/EmbeddedComputing/CompactP...

Chipset: Intel Ibex Peak
Found chipset: Atmel AT25DF641 8192Kb SPI at 0xff800000

I hope you can help

Best regards

Marco Runge

Marco Runge 
Software Engineer 
EDA BAD 
Raytheon Anschuetz GmbH

[phone] office
[phone] fax
[e-mail]

Zeyestrasse 16 - 24
D-24106 Kiel
Germany
www.raytheon-anschuetz.com

Raytheon Anschuetz GmbH
Sitz der Gesellschaft: Kiel
Registergericht: Amtsgericht Kiel HRB 4086
Geschaeftsfuehrer: Dr. Lueder Hogrefe
Vorsitzender des Aufsichtsrats: Patrick K. Peppe

Diese Nachricht enthaelt vertrauliche oder rechtlich geschuetzte 
Informationen. Wenn Sie nicht der beabsichtigte Empfaenger sind, 
informieren Sie bitte sofort den Absender und loeschen Sie diese 
Nachricht. Das unbefugte Kopieren dieser Nachricht oder die unbefugte 
Weitergabe der enthaltenen Informationen ist nicht gestattet.

The information contained in this message is confidential or protected by 
law. If you are not the intended recipient, please contact the sender and 
delete this message. Any unauthorized copying of this message or 
unauthorized distribution of the information contained herein is 
prohibited.