Re: Wont flash bios

[Angel Pons]

Hello,

Your reply did not reach the mailing list. Please use "Reply to all" so
that your messages can reach more people than just me.

On Tue, Mar 12, 2019, 09:06 Frei Bjerkestrand <[e-mail]
wrote:
> No I'm pretty sure the 1.8V is connected. Should I try to disassemble the
> programmer and the 1.8V converter and assemble it again?

So you are using a 1.8V converter between the programmer and the chip?

Regarding the original issue: If you can not change any bytes, I would
suspect the flash chip is write-protected. Check its datasheet, it is
likely pin 3 is somehow pulled low (write-protect pin is usually active
when low).

Regards,

Angel Pons
>