Macronix mx25l12845e can't read

[XVilka Haos of System]

Hello!
Reposting from local board:
flashrom trunk can't read or identify Macronix MX25L12345E

Here is the output of SPIPGM 2.19

/SPIPGM/SPIPGM64 /i

SPI FlashROM Programmer 2.19 (C) 2008-2014 by Martin Rehak; [e-mail]
Compiled by GCC 4.4.5 at 16:06:31, May  3 2014
(GNU/Linux compatability)

SPI connected to LPT port at I/O base address: 378h, SCK pulse width: t+0us
FlashROM JEDEC ID, type: C22018h
Macronix MX25L12835E/12836E/12873F (16MB)
Status = 00h (SRP, AAI, BP3, BP2, BP1, BP0, WEL, BSY)
               0    0    0    0    0    0    0    0

Found Macronix flash chip «MX25L12805(D)» (16384 kB, SPI) on rayer_spi.
Chip status register is 0x00.
Chip status register: Status Register Write Disable (SRWD, SRP, ...) is not set
Chip status register: Bit 6 is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Block Protect 2 (BP2) is not set
Chip status register: Block Protect 1 (BP1) is not set
Chip status register: Block Protect 0 (BP0) is not set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set

I've asked for full logs, but still no answer, so I'm sending this
just to save possible error or future chip/board target.

Best regards,
XVilka.