Hi there, 20cm wires is a bit long in my opinion - should be 10cm, but still - if your board is "hungry" - there may be a voltage drop and the resulting voltage level is insufficient for the successful flashing. As for "desoldered & flashed & soldered and nothing happens" - if you're confident your hardware is OK, then there may be an issue with a proprietary BIOS image that you are flashing, and I could only suggest searching for a good BIOS online or trying to extract it from a manufacturer's UEFI update utility if nothing helps.
On Thu, Mar 18, 2021 at 7:45 PM Aurelijus Gogas a.a.grigonis@gmail.com wrote:
Hallo again. I flashed winbond bios on asus x54h only when desoldered. But when I soldered back, there was nothing. Even light on laptop not lighting. I flashed smaller bios file by adding in begin file difference ( coppied from bricked bios). Are there some solutions? Thanks for answer.
With Best Regards Aurimas
Get BlueMail for Android On Mar 2, 2021, at 18:47, Aurelijus Gogas a.a.grigonis@gmail.com wrote:
I wired like schema. Resistors used like resistor divider signal-200 Om-to flash-200 Om-200 Om-GND. Wires are about 20cm. Wp, hold, vcc connected to 3.3v. when connected to external power supply, then flashrom wrote that is promblem with erase read or something. I wired SPI also as default pins (50-53)… and as schema (31-34).
Thanks
With Best Regards Aurimas
Get BlueMail for Android On Mar 2, 2021, at 18:27, Mike Banon < mikebdp2@gmail.com> wrote:
BV should also work fine. Please could you describe your flashing setup, length of wires etc.
On Sun, Feb 28, 2021 at 10:41 PM Aurelijus Gogas a.a.grigonis@gmail.com wrote:
Hallow,
Thanks for your work (flashrom). In hardware list there is w25q32, but mine is BV. Flashrom can not detect my chip. Is it not supported or i am doing something wrong? I wired like example in tutorial. I have arduino mega2560.
What i can do?
Thanks for help.
With Best Regards
Aurimas
Get BlueMail for Android
flashrom mailing list -- flashrom@flashrom.org
To unsubscribe send an email to flashrom-leave@flashrom.org