Hi I tried bios flashing and it ran perfectly till it verified at the end of writing the flash
C:\Users\Justin Hardy\Desktop\Flashrom_v1.2_St1cky>flashrom -w FLASH.ROM -p busp irate_spi:dev=COM5,spispeed=1M flashrom v1.2 on Windows 6.1 (x86_64) flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK. Found Winbond flash chip "W25Q32.V" (4096 kB, SPI) on buspirate_spi. Reading old flash chip contents... done. Erasing and writing flash chip... Erase/write done. Verifying flash... FAILED at 0x00000060! Expected=0x00, Found=0x01, failed byte count from 0x00000000-0x003fffff: 0xc0af Your flash chip is in an unknown state. Please report this on IRC at chat.freenode.net (channel #flashrom) or mail flashrom@flashrom.org, thanks!
C:\Users\Justin Hardy\Desktop\Flashrom_v1.2_St1cky>
At first I got a fail reading because I disconnected it somehow, then it worked and got this at the very end thanks!
Hi Justin,
sounds to mea s you´ve got problem with the signal quality. i.e. check your cable setting. Make sure contacts are good and cable length as short as possible (if they are quite long but you can´t shorten them: drill the whole cable to get the wires tight one to each other)
Before updating I would always make sure that reading works fine. i.e. run reading twice and compare read results. Only if they do not differ, I´d recommend to write.
Regards,
simon
Von: Justin Eazy Cheeze justin.hardy@outlook.com Gesendet: Mittwoch, 23. Dezember 2020 00:15 An: flashrom@flashrom.org Betreff: [flashrom] bios flash
Hi I tried bios flashing and it ran perfectly till it verified at the end of writing the flash
C:\Users\Justin Hardy\Desktop\Flashrom_v1.2_St1cky>flashrom -w FLASH.ROM -p busp irate_spi:dev=COM5,spispeed=1M flashrom v1.2 on Windows 6.1 (x86_64) flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK. Found Winbond flash chip "W25Q32.V" (4096 kB, SPI) on buspirate_spi. Reading old flash chip contents... done. Erasing and writing flash chip... Erase/write done. Verifying flash... FAILED at 0x00000060! Expected=0x00, Found=0x01, failed byte count from 0x00000000-0x003fffff: 0xc0af Your flash chip is in an unknown state. Please report this on IRC at chat.freenode.net (channel #flashrom) or mail flashrom@flashrom.orgmailto:flashrom@flashrom.org, thanks!
C:\Users\Justin Hardy\Desktop\Flashrom_v1.2_St1cky>
At first I got a fail reading because I disconnected it somehow, then it worked and got this at the very end thanks!
-
Buhrow, Simon -
Justin Eazy Cheeze