Re: [flashrom] [PATCH] Add ICH9 Engineering sample to chipset enables

[Carl-Daniel Hailfinger]

bouncing this mail...

On 21.08.2009 18:41, LE COQ ANNYVONNE wrote:
> Acked-by: Anne Le Coq
>
> Hi Carl-Daniel,
>
> It's the modification I've done to accept the ICH9, and it works fine. I just mention "ICH9" instead of "ICH9 Engineering Sample", but I don't think it's very important.
>
> My problem now is that the opcode 06 is unknown in the opcode table.
> To continue my test, I replace one of unused opcode (0B9H) by 06 and it's better. But it's not a good solution...
> Then, after that, I can only read, write and erase my flash till A000H.
> I think it's because I use the ICH9 in descriptor mode.
> I have the following fault: 
> ERROR at 0x0000a000: Expected=0xff, Read=0x00
> Have you got an idea about this issue ?
> Thanks
> Anne