flashrom v1.2 on Linux 5.15.58-2-lts (x86_64) flashrom is free software, get the source code at https://flashrom.org
flashrom was built with libpci 3.8.0, GCC 12.1.0, little endian Command line (3 args): flashrom --programmer internal -V Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns). Initializing internal programmer get_mtd_info: device_name: "intel-spi", is_writeable: 0, numeraseregions: 0, total_size: 8388608, erasesize: 4096 No coreboot table found. Using Internal DMI decoder. No DMI table found. Found chipset "Intel Lynx Point LP Premium" with PCI ID 8086:9c43. This chipset is marked as untested. If you are using an up-to-date version of flashrom *and* were (not) able to successfully update your firmware with it, then please email a report to flashrom@flashrom.org including a verbose (-V) log. Thank you! Enabling flash write... Root Complex Register Block address = 0xfed1c000 GCS = 0x61: BIOS Interface Lock-Down: enabled, Boot BIOS Straps: 0x0 (SPI) Top Swap: not enabled 0x7fffffff/0x7fffffff FWH IDSEL: 0x0 0x7fffffff/0x7fffffff FWH IDSEL: 0x0 0x7fffffff/0x7fffffff FWH IDSEL: 0x1 0x7fffffff/0x7fffffff FWH IDSEL: 0x1 0x7fffffff/0x7fffffff FWH IDSEL: 0x2 0x7fffffff/0x7fffffff FWH IDSEL: 0x2 0x7fffffff/0x7fffffff FWH IDSEL: 0x3 0x7fffffff/0x7fffffff FWH IDSEL: 0x3 0x7fffffff/0x7fffffff FWH IDSEL: 0x4 0x7fffffff/0x7fffffff FWH IDSEL: 0x5 0x7fffffff/0x7fffffff FWH IDSEL: 0x6 0x7fffffff/0x7fffffff FWH IDSEL: 0x7 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode disabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled 0x7fffffff/0x7fffffff FWH decode enabled Maximum FWH chip size: 0x100000 bytes SPI Read Configuration: prefetching enabled, caching enabled, BIOS_CNTL = 0x2a: BIOS Lock Enable: enabled, BIOS Write Enable: disabled SPIBAR = 0x00007fc4b4d56000 + 0x3800 0x04: 0xe008 (HSFS) HSFS: FDONE=0, FCERR=0, AEL=0, BERASE=1, SCIP=0, FDOPSS=1, FDV=1, FLOCKDN=1 SPI Configuration is locked down. Reading OPCODES... done 0x06: 0x0000 (HSFC) HSFC: FGO=0, FCYCLE=0, FDBC=0, SME=0 0x50: 0x00004a4b (FRAP) BMWAG 0x00, BMRAG 0x00, BRWA 0x4a, BRRA 0x4b 0x54: 0x00000000 FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only. 0x58: 0x07ff0400 FREG1: BIOS region (0x00400000-0x007fffff) is read-write. 0x5C: 0x03ff0001 FREG2: Management Engine region (0x00001000-0x003fffff) is locked. Not all flash regions are freely accessible by flashrom. This is most likely due to an active ME. Please see https://flashrom.org/ME for details. 0x90: 0xc4 (SSFS) SSFS: SCIP=0, FDONE=1, FCERR=0, AEL=0 0x91: 0xfc4540 (SSFC) SSFC: SCGO=0, ACS=0, SPOP=0, COP=4, DBC=5, SME=0, SCF=4 0x94: 0x0006 (PREOP) 0x96: 0x043b (OPTYPE) 0x98: 0x05203b02 (OPMENU) 0x9c: 0x0000019f (OPMENU+4) 0xa0: 0x00000000 (BBAR) 0xc4: 0x80802025 (LVSCC) LVSCC: BES=0x1, WG=1, WSR=0, WEWS=0, EO=0x20, VCL=1 0xc8: 0x00002025 (UVSCC) UVSCC: BES=0x1, WG=1, WSR=0, WEWS=0, EO=0x20 0xd0: 0x50444653 (FPB) Enabling hardware sequencing because some important opcode is locked. OK. The following protocols are supported: Programmer-specific. Probing for Programmer Opaque flash chip, 0 kB: Hardware sequencing reports 1 attached SPI flash chip with a density of 8192 kB. The first partition ranges from 0x000000 to 0x652fff. In that range are 1619 erase blocks with 4096 B each. The second partition ranges from 0x653000 to 0x7fffff. In that range are 429 erase blocks with 4096 B each. Found Programmer flash chip "Opaque flash chip" (8192 kB, Programmer-specific) mapped at physical address 0x0000000000000000. Found Programmer flash chip "Opaque flash chip" (8192 kB, Programmer-specific). No operations were specified. Restoring MMIO space at 0x7fc4b4d598a0 Restoring PCI config space for 00:1f:0 reg 0xdc
-
Wagner Rodrigo