- introduce offset macros and use them to (re)define the existing mask macros - add comments - rename SSFS_CDS to SSFS_FDONE (abbr. used in datasheet not in SSFS but HSFS) - use those for refactoring and magic number elemination. - following patch uses them for pretty printing
Signed-off-by: Stefan Tauner stefan.tauner@student.tuwien.ac.at --- ichspi.c | 48 ++++++++++++++++++++++++++++++------------------ 1 files changed, 30 insertions(+), 18 deletions(-)
diff --git a/ichspi.c b/ichspi.c index 6370fb6..1cfdf48 100644 --- a/ichspi.c +++ b/ichspi.c @@ -47,24 +47,36 @@ #define ICH9_REG_FDATA0 0x10 /* 64 Bytes */
#define ICH9_REG_SSFS 0x90 /* 08 Bits */ -#define SSFS_SCIP 0x00000001 -#define SSFS_CDS 0x00000004 -#define SSFS_FCERR 0x00000008 -#define SSFS_AEL 0x00000010 +#define SSFS_SCIP_OFF 0 /* SPI Cycle In Progress */ +#define SSFS_SCIP (0x1 << SSFS_SCIP_OFF) +#define SSFS_FDONE_OFF 2 /* Cycle Done Status */ +#define SSFS_FDONE (0x1 << SSFS_FDONE_OFF) +#define SSFS_FCERR_OFF 3 /* Flash Cycle Error */ +#define SSFS_FCERR (0x1 << SSFS_FCERR_OFF) +#define SSFS_AEL_OFF 4 /* Access Error Log */ +#define SSFS_AEL (0x1 << SSFS_AEL_OFF) /* The following bits are reserved in SSFS: 1,5-7. */ #define SSFS_RESERVED_MASK 0x000000e2
#define ICH9_REG_SSFC 0x91 /* 24 Bits */ -#define SSFC_SCGO 0x00000200 -#define SSFC_ACS 0x00000400 -#define SSFC_SPOP 0x00000800 -#define SSFC_COP 0x00001000 -#define SSFC_DBC 0x00010000 -#define SSFC_DS 0x00400000 -#define SSFC_SME 0x00800000 -#define SSFC_SCF 0x01000000 -#define SSFC_SCF_20MHZ 0x00000000 -#define SSFC_SCF_33MHZ 0x01000000 +#define SSFC_SCGO_OFF (1 + 8) /* 1: SPI Cycle Go */ +#define SSFC_SCGO (0x1 << SSFC_SCGO_OFF) +#define SSFC_ACS_OFF (2 + 8) /* 2: Atomic Cycle Sequence */ +#define SSFC_ACS (0x1 << SSFC_ACS_OFF) +#define SSFC_SPOP_OFF (3 + 8) /* 3: Sequence Prefix Opcode Pointer */ +#define SSFC_SPOP (0x1 << SSFC_SPOP_OFF) +#define SSFC_COP_OFF (4 + 8) /* 4-6: Cycle Opcode Pointer */ +#define SSFC_COP (0x7 << SSFC_COP_OFF) +#define SSFC_DBC_OFF (8 + 8) /* 8-13: Data Byte Count */ +#define SSFC_DBC (0x3f << SSFC_DBC_OFF) +#define SSFC_DS_OFF (14 + 8) /* 14: Data Cycle */ +#define SSFC_DS (0x1 << SSFC_DS_OFF) +#define SSFC_SME_OFF (15 + 8) /* 15: SPI SMI# Enable */ +#define SSFC_SME (0x1 << SSFC_SME_OFF) +#define SSFC_SCF_OFF (16 + 8) /* 16-18: SPI Cycle Frequency */ +#define SSFC_SCF (0x7 << SSFC_SCF_OFF) +#define SSFC_SCF_20MHZ 0x00000000 +#define SSFC_SCF_33MHZ 0x01000000 /* We combine SSFS and SSFC to one 32-bit word, * therefore SSFC bits are off by 8. * The following bits are reserved in SSFC: 23-19,7,0. */ @@ -709,8 +721,8 @@ static int ich9_run_opcode(OPCODE op, uint32_t offset, temp32 = REGREAD32(ICH9_REG_SSFS); /* Keep reserved bits only */ temp32 &= SSFS_RESERVED_MASK | SSFC_RESERVED_MASK; - /* clear error status registers */ - temp32 |= (SSFS_CDS + SSFS_FCERR); + /* Clear cycle done and cycle error status registers */ + temp32 |= (SSFS_FDONE + SSFS_FCERR); REGWRITE32(ICH9_REG_SSFS, temp32);
/* Use 20 MHz */ @@ -720,7 +732,7 @@ static int ich9_run_opcode(OPCODE op, uint32_t offset, if (datalength != 0) { uint32_t datatemp; temp32 |= SSFC_DS; - datatemp = ((uint32_t) ((datalength - 1) & 0x3f)) << (8 + 8); + datatemp = (uint32_t) (((datalength - 1) << SSFC_DBC_OFF) & SSFC_DBC); temp32 |= datatemp; }
@@ -767,7 +779,7 @@ static int ich9_run_opcode(OPCODE op, uint32_t offset, REGWRITE32(ICH9_REG_SSFS, temp32);
/* Wait for Cycle Done Status or Flash Cycle Error. */ - while (((REGREAD32(ICH9_REG_SSFS) & (SSFS_CDS | SSFS_FCERR)) == 0) && + while (((REGREAD32(ICH9_REG_SSFS) & (SSFS_FDONE | SSFS_FCERR)) == 0) && --timeout) { programmer_delay(10); }
-
Stefan Tauner