Hello all,
I have successfully flashed a N25Q128..1E SPI flash using flashrom with a 16MB image. The programmer was an external one: NI USB-8452. This is not supported in the mainline yet, but patch is coming soon.
/Flashing output (I have forgotten to //run with -V//):// //flashrom v0.9.7-unknown on Linux 3.13.0-70-generic (x86_64)// //flashrom is free software, get the source code at http://www.flashrom.org// // //Calibrating delay loop... OK.// //Found USB device (3923:7514).// //USB-8452 IO voltage set to: 1.8 V// //USB-8452 SCK frequency set to: 50.00 MHz// //Found Micron/Numonyx/ST flash chip "N25Q128..1E" (16384 kB, SPI) on usb8451_spi.// //===// //This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE// //The test status of this chip may have been updated in the latest development// //version of flashrom. If you are running the latest development version,// //please email a report to flashrom@flashrom.org if any of the above operations// //work correctly for you with this flash part. Please include the flashrom// //output with the additional -V option for all operations you tested (-V, -Vr,// //-VE, -Vw), and mention which mainboard or programmer you tested.// //Please mention your board in the subject line. Thanks for your help!// //Reading old flash chip contents... done.// //Erasing and writing flash chip... // //Erase/write done.// //Verifying flash... VERIFIED.
/Patch attached./ /