Hello all,
I have successfully flashed a N25Q128..1E SPI
flash using flashrom with a 16MB image.
The programmer was an external one: NI USB-8452. This is not
supported in the mainline yet, but patch is coming soon.
Flashing output (I have forgotten to run with -V):
flashrom v0.9.7-unknown on Linux 3.13.0-70-generic (x86_64)
flashrom is free software, get the source code at
http://www.flashrom.org
Calibrating delay loop... OK.
Found USB device (3923:7514).
USB-8452 IO voltage set to: 1.8 V
USB-8452 SCK frequency set to: 50.00 MHz
Found Micron/Numonyx/ST flash chip "N25Q128..1E"
(16384 kB, SPI) on usb8451_spi.
===
This flash part has status UNTESTED for
operations: PROBE READ ERASE WRITE
The test status of this chip may have been updated
in the latest development
version of flashrom. If you are running the latest
development version,
please email a report to flashrom@flashrom.org if
any of the above operations
work correctly for you with this flash part.
Please include the flashrom
output with the additional -V option for all
operations you tested (-V, -Vr,
-VE, -Vw), and mention which mainboard or
programmer you tested.
Please mention your board in the subject line.
Thanks for your help!
Reading old flash chip contents... done.
Erasing and writing flash chip...
Erase/write done.
Verifying flash... VERIFIED.
Patch attached.
--
Regards,
Miklos Marton