Here are the results for this chip.
Tested with Arduino (serprog).
The writing (sign) on the Chip is:
Should i test something else?
BTW: This chip was found on a "newer" nvidia graphic card (GF108 /
Gforce GT430 / 1GB Ram).
31 Jan 2015 and 1 Feb 2015:
I would love to be there again and some of you already said they'd try
to be there, but I forgot who. Who can be there with me at the booth and
when can you be there?
A preliminary stand application has already been sent by me to somewhat
hit the deadline, but I'd like to fill it in a bit more.
Side note: If someone has an interesting topic for a lightning talk,
please submit one!
attached patch adds a BUILD_EVERYTHING flag to Makefile
that sets all CONFIG_* flags to "yes" if they were "no".
This provides a comfortable way to ensure maximum code exposure
to tools like coverity or clang's scan-build.
BUILD_EVERYTHING will likely fail on non-Linux/x86 systems,
but it seems that's a hard dependency to compile everything at
this time, so well...
Signed-off-by: Patrick Georgi <patrick(a)georgi-clan.de>
I have a P5GC-MX/133 (Rev 305g). This model is listed as supported on the
website*, After building trunk from source, I invoked flashrom as shown,
but the tool indicates the board is not supported. Am I missing something?
# flashrom --programmer internal:mainboard=ASUS:P5GC-MX/1333
flashrom v0.9.7-r1850 on Linux 2.6.32-65-generic (i686)
flashrom is free software, get the source code at http://www.flashrom.org
Calibrating delay loop... OK.
Found chipset "Intel ICH7/ICH7R". Enabling flash write... OK.
No suitable board enable found for vendor="ASUS", model="P5GC-MX/1333".
Aborting to be safe.
Error: Programmer initialization failed.
* Apparently per http://flashrom.org/pipermail/flashrom/2010-June/003501.html
I have successfully flashed a EN25Q64 that was rated untested. It was
for an 8MB version of openWRT.
My setup was a Raspberry Pi with flashrom 0.9.5.2-r1546 and Linux
3.12.22+. I made a little SMD adapter like shown in the picture that
plugs directly in the Pi header.
This serie is adding the Eon EN29LV040A.
It was tested with the following programmer(satasii):
04:06.0 RAID bus controller : Silicon Image, Inc. PCI0680 Ultra ATA-133 Host Controller [1095:0680] (rev 02)
Do I need to send flashrom -VV logs too?
I'm attaching a patch which adds support for Spansion S25FL127S flash chip in 64KiB and 256KiB mode. I also tested 64KiB mode with FT4232H Mini Module which works fine (please see attached logs).