[PATCH 1/3] serprog: clear NDELAY flag only once after opening the port.

[Stefan Tauner]

Change sp_openserport() to directly clear the O_NONBLOCK flag that
is potentially set by opening the device with O_NDELAY instead of
clearing ALL flags in serialport_config() unconditionally.

Signed-off-by: Stefan Tauner 
---
 serial.c | 18 +++++++++++++-----
 1 file changed, 13 insertions(+), 5 deletions(-)

diff --git a/serial.c b/serial.c
index 94f9b7d..63774a5 100644
--- a/serial.c
+++ b/serial.c
@@ -183,10 +183,6 @@ int serialport_config(fdtype fd, unsigned int baud)
    msg_pdbg("Baud rate is %ld.\n", dcb.BaudRate);
 #else
    struct termios wanted, observed;
-	if (fcntl(fd, F_SETFL, 0) != 0) {
-		msg_perr_strerror("Could not clear serial port mode: ");
-		return 1;
-	}
    if (tcgetattr(fd, &observed) != 0) {
    	msg_perr_strerror("Could not fetch original serial port configuration: ");
    	return 1;
@@ -254,11 +250,23 @@ fdtype sp_openserport(char *dev, unsigned int baud)
    }
    return fd;
 #else
-	fd = open(dev, O_RDWR | O_NOCTTY | O_NDELAY);
+	fd = open(dev, O_RDWR | O_NOCTTY | O_NDELAY); // Use O_NDELAY to ignore DCD state
    if (fd < 0) {
    	msg_perr_strerror("Cannot open serial port: ");
    	return SER_INV_FD;
    }
+
+	/* Ensure that we use blocking I/O */
+	const int flags = fcntl(fd, F_GETFL);
+	if (flags == -1) {
+		msg_perr_strerror("Could not get serial port mode: ");
+		return SER_INV_FD;
+	}
+	if (fcntl(fd, F_SETFL, flags & ~O_NONBLOCK) != 0) {
+		msg_perr_strerror("Could not set serial port mode to blocking: ");
+		return SER_INV_FD;
+	}
+
    if (serialport_config(fd, baud) != 0) {
    	close(fd);
    	return SER_INV_FD;