flashrom v0.9.7-r1850 on Linux 4.9.4-201.fc25.x86_64 (x86_64)
flashrom is free software, get the source code at http://www.flashrom.org
flashrom was built with libpci 3.4.1, GCC 6.0.0 20160201 (Red Hat
6.0.0-0.9), little endian
Command line (3 args): flashrom -V -p internal
Calibrating delay loop... OS timer resolution is 2 usecs, 370M loops per
second, 10 myus = 10 us, 100 myus = 132 us, 1000 myus = 1015 us, 10000
myus = 13591 us, 8 myus = 13 us, OK.
Initializing internal programmer
No coreboot table found.
Using External DMI decoder.
DMI string chassis-type: "Notebook"
Laptop detected via DMI.
DMI string system-manufacturer: "Hewlett-Packard"
DMI string system-product-name: "HP Mini 110-3100 "
DMI string system-version: "058F110000202B00000300100"
DMI string baseboard-manufacturer: "Hewlett-Packard"
DMI string baseboard-product-name: "148A"
DMI string baseboard-version: "79.49"
W836xx enter config mode worked or we were already in config mode.
W836xx leave config mode had no effect.
Active config mode, unknown reg 0x20 ID: 85.
Please send the output of "flashrom -V -p internal" to
flashrom(a)flashrom.org with W836xx: your board name: flashrom -V
as the subject to help us finish support for your Super I/O. Thanks.
Found ITE EC, ID 0x8500, Rev 0x01 on port 0x4e.
WARNING! You seem to be running flashrom on an unsupported laptop.
Laptops, notebooks and netbooks are difficult to support and we
recommend to use the vendor flashing utility. The embedded controller
(EC) in these machines often interacts badly with flashing.
See the manpage and http://www.flashrom.org/Laptops
If flash is shared with the EC, erase is guaranteed to brick your laptop
and write may brick your laptop.
Read and probe may irritate your EC and cause fan failure, backlight
failure and sudden poweroff.
You have been warned.
Error: Programmer initialization failed.