Question about SIL3114 board with a N28F010-120 flash chip on it

Nov. 30, 2018
9:06 a.m.
Dear Reader, I have a SIL3114 PCI board with an Intel N28F010-120 flash chip on it, and I can't reprogram it since it lacks the 12V Vpp. I checked that there is no +12V connection on the PCI edge connector of the board and the VPP pin seems to be unconnected. My question is this. When I apply 12V Vpp to the chip will I then be able to reprogram the board with the Lattice (Silicon Image) dos utility or the flashrom utility. I am an experienced engineer, but my eprom day's are from way back in the 80's and early 90's and I have never done anything with flash proms other than reprogramming boards with the supplied software. Thanks for any response. Kind regards, Peter Cost
2396
Age (days ago)
2396
Last active (days ago)
0 comments
1 participants
participants (1)
-
Peter Cost