Also, correct prettyprinting of the registers of the various families, and abort if SpiAccessMacRomEn or SpiHostAccessRomEn prohibit full access.
Tested reading/writing on ASRock IMB-A180, and chipset detection on one of each affected generation by Chris Goodrich from Sage.
Signed-off-by: Stefan Tauner stefan.tauner@student.tuwien.ac.at --- sb600spi.c | 133 ++++++++++++++++++++++++++++++++++++++++++++++++------------- 1 file changed, 106 insertions(+), 27 deletions(-)
diff --git a/sb600spi.c b/sb600spi.c index cb7c4ac..c9be44c 100644 --- a/sb600spi.c +++ b/sb600spi.c @@ -57,7 +57,28 @@ static enum amd_chipset amd_gen = CHIPSET_AMD_UNKNOWN; static void determine_generation(struct pci_dev *dev) { amd_gen = CHIPSET_AMD_UNKNOWN; - if (dev->device_id == 0x780e) { + msg_pdbg2("Trying to determine the generation of the SPI interface... "); + if (dev->device_id == 0x438d) { + amd_gen = CHIPSET_SB6XX; + msg_pdbg("SB6xx detected.\n"); + } else if (dev->device_id == 0x439d) { + struct pci_dev *smbus_dev = pci_dev_find(0x1002, 0x4385); + if (smbus_dev == NULL) + return; + uint8_t rev = pci_read_byte(smbus_dev, PCI_REVISION_ID); + if (rev >= 0x39 && rev <= 0x3D) { + amd_gen = CHIPSET_SB7XX; + msg_pdbg("SB7xx/SP5100 detected.\n"); + } else if (rev >= 0x40 && rev <= 0x42) { + amd_gen = CHIPSET_SB89XX; + msg_pdbg("SB8xx/SB9xx/Hudson-1 detected.\n"); + } else { + msg_pwarn("SB device found but SMBus revision 0x%02x does not match known values.\n" + "Assuming SB8xx/SB9xx/Hudson-1. Please send a log to flashrom@flashrom.org\n", + rev); + amd_gen = CHIPSET_SB89XX; + } + } else if (dev->device_id == 0x780e) { /* The PCI ID of the LPC bridge doesn't change between Hudson-2/3/4 and Yangtze (Kabini/Temash) * although they use different SPI interfaces. */ #ifdef USE_YANGTZE_HEURISTICS @@ -94,7 +115,11 @@ static void determine_generation(struct pci_dev *dev) "the output of lspci -nnvx, thanks!.\n", rev); } #endif - } + } else + msg_pwarn("%s: Unknown LPC device %" PRIx16 ":%" PRIx16 ".\n" + "Please report this to flashrom@flashrom.org and include this log and\n" + "the output of lspci -nnvx, thanks!\n", + __func__, dev->vendor_id, dev->device_id); }
static void reset_internal_fifo_pointer(void) @@ -250,7 +275,7 @@ static int sb600_spi_send_command(struct flashctx *flash, unsigned int writecnt, static int sb600_handle_imc(struct pci_dev *dev, bool amd_imc_force) { /* Handle IMC everywhere but sb600 which does not have one. */ - if (dev->device_id == 0x438d) + if (amd_gen == CHIPSET_SB6XX) return 0;
/* TODO: we should not only look at IntegratedImcPresent (LPC Dev 20, Func 3, 40h) but also at @@ -334,6 +359,12 @@ int sb600_probe_spi(struct pci_dev *dev) sb600_spibar += tmp & 0xfff;
determine_generation(dev); + if (amd_gen == CHIPSET_AMD_UNKNOWN) { + /* FIXME: Eventually this should be a fatal error, but until we are certain to have covered all + * IDs actually found in the wild, try to mimmick the previous behavior. */ + msg_pwarn("Could not determine chipset generation. Assuming SB6xx."); + amd_gen = CHIPSET_SB6XX; + }
if (amd_gen == CHIPSET_YANGTZE) { msg_perr("SPI on Kabini/Temash and newer chipsets are not yet supported.\n" @@ -341,35 +372,83 @@ int sb600_probe_spi(struct pci_dev *dev) return ERROR_NONFATAL; }
- tmp = pci_read_long(dev, 0xa0); - msg_pdbg("AltSpiCSEnable=%i, SpiRomEnable=%i, " - "AbortEnable=%i\n", tmp & 0x1, (tmp & 0x2) >> 1, - (tmp & 0x4) >> 2); - tmp = (pci_read_byte(dev, 0xba) & 0x4) >> 2; - msg_pdbg("PrefetchEnSPIFromIMC=%i, ", tmp); - - tmp = pci_read_byte(dev, 0xbb); - /* FIXME: Set bit 3,6,7 if not already set. - * Set bit 5, otherwise SPI accesses are pointless in LPC mode. - * See doc 42413 AMD SB700/710/750 RPR. + /* Chipset support matrix for SPI Base_Addr (LPC PCI reg 0xa0) + * bit 6xx 7xx/SP5100 8xx 9xx hudson1 hudson2+ yangtze + * 3 rsvd <- <- ? <- ? RouteTpm2Spi + * 2 rsvd AbortEnable rsvd ? <- ? <- + * 1 rsvd SpiRomEnable <- ? <- ? <- + * 0 rsvd AltSpiCSEnable<1> rsvd ? <- ? <- + * + * <1> It is unknown if that was ever working. On later chipsets the CS config is at memmapped 0x1D. */ - msg_pdbg("PrefetchEnSPIFromHost=%i, SpiOpEnInLpcMode=%i\n", - tmp & 0x1, (tmp & 0x20) >> 5); - tmp = mmio_readl(sb600_spibar); - /* FIXME: If SpiAccessMacRomEn or SpiHostAccessRomEn are zero on - * SB700 or later, reads and writes will be corrupted. Abort in this - * case. Make sure to avoid this check on SB600. + if (amd_gen >= CHIPSET_SB7XX) { + tmp = pci_read_long(dev, 0xa0); + msg_pdbg("SpiRomEnable=%i", (tmp >> 1) & 0x1); + if (amd_gen == CHIPSET_SB7XX) + msg_pdbg(", AltSpiCSEnable=%i, AbortEnable=%i", tmp & 0x1, (tmp >> 2) & 0x1); + + tmp = pci_read_byte(dev, 0xba); + msg_pdbg(", PrefetchEnSPIFromIMC=%i", (tmp & 0x4) >> 2); + + tmp = pci_read_byte(dev, 0xbb); + /* FIXME: Set bit 3,6,7 if not already set. + * Set bit 5, otherwise SPI accesses are pointless in LPC mode. + * See doc 42413 AMD SB700/710/750 RPR. + */ + if (amd_gen == CHIPSET_SB7XX) + msg_pdbg(", SpiOpEnInLpcMode=%i", (tmp >> 5) & 0x1); + msg_pdbg(", PrefetchEnSPIFromHost=%i\n", tmp & 0x1); + } + + /* Chipset support matrix for SPI_Cntrl0 (spibar + 0x0) + * bit 6xx 7xx/SP5100 8xx 9xx hudson1 hudson2+ yangtze + * 17 rsvd <- <- ? <- ? <- + * 18 rsvd <- fastReadEnable<1> ? <- ? SpiReadMode[0]<1> + * 19 SpiArbEnable <- <- ? <- ? <- + * 20 (FifoPtrClr) <- <- ? <- ? <- + * 21 (FifoPtrInc) <- <- ? <- ? IllegalAccess + * 22 SpiAccessMacRomEn <- <- ? <- ? <- + * 23 SpiHostAccessRomEn <- <- ? <- ? <- + * 24:26 ArbWaitCount <- <- ? <- ? <- + * 27 SpiBridgeDisable <- <- ? <- ? rsvd + * 28 rsvd DropOneClkOnRd = SPIClkGate ? <- ? <- + * 29:30 rsvd <- <- ? <- ? SpiReadMode[2:1]<1> + * 31 rsvd <- SpiBusy ? <- ? <- + * + * <1> see handle_speed */ - msg_pdbg("(0x%08" PRIx32 ") fastReadEnable=%u, SpiArbEnable=%i, SpiAccessMacRomEn=%i, " - "SpiHostAccessRomEn=%i, ArbWaitCount=%i, " - "SpiBridgeDisable=%i, DropOneClkOnRd=%i\n", - tmp, (tmp >> 18) & 0x1, - (tmp >> 19) & 0x1, (tmp >> 22) & 0x1, - (tmp >> 23) & 0x1, (tmp >> 24) & 0x7, - (tmp >> 27) & 0x1, (tmp >> 28) & 0x1); + tmp = mmio_readl(sb600_spibar + 0x00); + msg_pdbg("(0x%08" PRIx32 ") SpiArbEnable=%i", tmp, (tmp >> 19) & 0x1); + + msg_pdbg(", SpiAccessMacRomEn=%i, SpiHostAccessRomEn=%i, ArbWaitCount=%i", + (tmp >> 22) & 0x1, (tmp >> 23) & 0x1, (tmp >> 24) & 0x7); + + if (amd_gen != CHIPSET_YANGTZE) + msg_pdbg(", SpiBridgeDisable=%i", (tmp >> 27) & 0x1); + + switch (amd_gen) { + case CHIPSET_SB7XX: + msg_pdbg(", DropOneClkOnRd/SpiClkGate=%i", (tmp >> 28) & 0x1); + case CHIPSET_SB89XX: + case CHIPSET_HUDSON234: + msg_pdbg(", SpiBusy=%i", (tmp >> 31) & 0x1); + default: break; + } + msg_pdbg("\n"); + + if (((tmp >> 22) & 0x1) == 0 || ((tmp >> 23) & 0x1) == 0) { + msg_perr("ERROR: State of SpiAccessMacRomEn or SpiHostAccessRomEn prohibits full access.\n"); + return ERROR_NONFATAL; + } + tmp = (mmio_readb(sb600_spibar + 0xd) >> 4) & 0x3; msg_pdbg("NormSpeed is %s MHz\n", speed_names[tmp]);
+ if (amd_gen >= CHIPSET_SB89XX) { + tmp = mmio_readb(sb600_spibar + 0x1D); + msg_pdbg("Using SPI_CS%d\n", tmp & 0x3); + } + /* Look for the SMBus device. */ smbus_dev = pci_dev_find(0x1002, 0x4385); if (!smbus_dev) {
-
Stefan Tauner