On Sat, Jul 04, 2009 at 04:12:06PM +0200, Arvid Brodin wrote:
Hi.
I tested flashrom on my Jetway J7F5M motherboard.
# flashrom Calibrating delay loop... OK. No coreboot table found. Found chipset "VIA CX700", enabling flash write... OK. Found chip "Winbond W39V040B" (512 KB) at physical address 0xfff80000. No operations were specified.
So probing seems to work ok, as do reading. Writing, however, does not work - the image on the flash chip remains unchanged (had a sweaty moment after the FAILED message before I had read the chip again and diffed it against the backed-up original image!).
The "Protect flash part" option in BIOS is set to Disabled (I also tried Enabled, just to be sure).
Is there any hope on getting flashrom support for this card? The AWDFLASH.EXE utility recommended for flashing by Jetway is "only" some sixty thousand bytes - any hints on reverse engineering this?
The computer is head-, FD- and CDR-less and runs linux, so it's a chore to flash it with the d**n DOS utility...
-- Arvid
Please provide the output of lspci -vnn.
Luc Verhaegen.