This patch has been tested on a board similar to AMD Bettong.
00:14.0 SMBus [0c05]: Advanced Micro Devices, Inc. [AMD] FCH SMBus Controller [1022:790b] (rev 4a) 00:14.3 ISA bridge [0601]: Advanced Micro Devices, Inc. [AMD] FCH LPC Bridge [1022:790e] (rev 11) root@qt5022-fglrx:~# ./flashrom -p internal -w kk.rom
flashrom v0.9.9-unknown on Linux 4.10.0-qtec-standard (x86_64) flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK. coreboot table found at 0x9ffd6000. Found chipset "AMD FP4". Enabling flash write... OK. Found Micron/Numonyx/ST flash chip "N25Q128..1E" (16384 kB, SPI) mapped at physical address 0x00000000ff000000. Reading old flash chip contents... done. Erasing and writing flash chip... Erase/write done. Verifying flash... VERIFIED.
Signed-off-by: Ricardo Ribalda Delgado ricardo.ribalda@gmail.com --- chipset_enable.c | 1 + sb600spi.c | 28 +++++++++++++++++++++++----- 2 files changed, 24 insertions(+), 5 deletions(-)
diff --git a/chipset_enable.c b/chipset_enable.c index b181b9349b02..82bac112a29c 100644 --- a/chipset_enable.c +++ b/chipset_enable.c @@ -1492,6 +1492,7 @@ const struct penable chipset_enables[] = { {0x1022, 0x7440, OK, "AMD", "AMD-768", enable_flash_amd_768_8111}, {0x1022, 0x7468, OK, "AMD", "AMD-8111", enable_flash_amd_768_8111}, {0x1022, 0x780e, OK, "AMD", "FCH", enable_flash_sb600}, + {0x1022, 0x790e, OK, "AMD", "FP4", enable_flash_sb600}, {0x1039, 0x0406, NT, "SiS", "501/5101/5501", enable_flash_sis501}, {0x1039, 0x0496, NT, "SiS", "85C496+497", enable_flash_sis85c496}, {0x1039, 0x0530, OK, "SiS", "530", enable_flash_sis530}, diff --git a/sb600spi.c b/sb600spi.c index 6bd56798e839..68f8d8ac532b 100644 --- a/sb600spi.c +++ b/sb600spi.c @@ -149,6 +149,23 @@ static void determine_generation(struct pci_dev *dev) "Please report this to flashrom@flashrom.org and include this log and\n" "the output of lspci -nnvx, thanks!.\n", rev); } + } else if (dev->device_id == 0x790e) { + struct pci_dev *smbus_dev = pci_dev_find(0x1022, 0x790B); + if (smbus_dev == NULL) { + msg_pdbg("No SMBus device with ID 1022:790B found.\n"); + return; + } + uint8_t rev = pci_read_byte(smbus_dev, PCI_REVISION_ID); + if (rev == 0x4a) { + amd_gen = CHIPSET_YANGTZE; + msg_pdbg("Yangtze detected.\n"); + } else { + msg_pwarn("FCH device found but SMBus revision 0x%02x does not match known values.\n" + "Please report this to flashrom@flashrom.org and include this log and\n" + "the output of lspci -nnvx, thanks!.\n", rev); + } + + #endif } else msg_pwarn("%s: Unknown LPC device %" PRIx16 ":%" PRIx16 ".\n" @@ -646,12 +663,13 @@ int sb600_probe_spi(struct pci_dev *dev)
/* Look for the SMBus device. */ smbus_dev = pci_dev_find(0x1002, 0x4385); - if (!smbus_dev) { + if (!smbus_dev) smbus_dev = pci_dev_find(0x1022, 0x780b); /* AMD FCH */ - if (!smbus_dev) { - msg_perr("ERROR: SMBus device not found. Not enabling SPI.\n"); - return ERROR_NONFATAL; - } + if (!smbus_dev) + smbus_dev = pci_dev_find(0x1022, 0x790b); /* AMD FP4 */ + if (!smbus_dev) { + msg_perr("ERROR: SMBus device not found. Not enabling SPI.\n"); + return ERROR_NONFATAL; }
/* Note about the bit tests below: If a bit is zero, the GPIO is SPI. */