Carl-Daniel Hailfinger wrote:
On 16.09.2009 19:07, Stefan Reinauer wrote:
Carl-Daniel Hailfinger wrote:
For optimal partial reflashing, we have to find out which parts of the chip can be written without erase. For that, the only criterion (except a limit on the number of writes for very old chips) is whether the write will only clear bits (set them to 0). If (current&new==new) we can skip the erase. If any bit would have to be set to 1, we need to erase.
Is that sufficient? Ie is it always ok to skip an erase if we're only clearing bits?
It depends on the chip, but given that the following appears in the ICH7 and all later datasheets as absolute flash requirement, I'm positive most current flash chips support it.
The system BIOS and Intel® Active Management Technology firmware usage models require that the serial flash device support multiple writes (minimum of 512 writes) to a page (256 bytes) without requiring a preceding erase command.
That means you can theoretically write it twice (2*256 byte writes on an x8 device) without erasing it. I don't think this is something we should rely on.
It also says serial flash device, which implies that LPC/FWH might behave differently.
Stefan