Hi,
I'm testing an Amontec JtagKey-tiny interface for programming a SST25VF040B eeprom i'm using in a project. The Jtagkey-tiny is detected without problems, it reads the eeprom ID and is detected.
But when i try to read it contents, i get an error:
$ ./flashrom -p ft2232_spi:type=jtagkey,port=A -Vr test.bin flashrom v0.9.3-r1205 on Linux 2.6.32-26-generic (i686), built with libpci 3.0.0, GCC 4.4.3, little endian flashrom is free software, get the source code at http://www.flashrom.org
Calibrating delay loop... OS timer resolution is 2 usecs, 1000M loops per second, 10 myus = 11 us, 100 myus = 91 us, 1000 myus = 904 us, 10000 myus = 9823 us, 8 myus = 10 us, OK. Initializing ft2232_spi programmer Using device type Amontec JTAGkey interface A Set clock divisor SPI clock is 2.000000MHz No loopback of TDI/DO TDO/DI Set data bits [Probings ommited] Probing for SST SST25VF040B, 512 KB: probe_spi_rdid_generic: id1 0xbf, id2 0x258d Chip status register is bf Chip status register: Block Protect Write Disable (BPL) is set Chip status register: Auto Address Increment Programming (AAI) is not set Chip status register: Bit 5 / Block Protect 3 (BP3) is set Chip status register: Bit 4 / Block Protect 2 (BP2) is set Chip status register: Bit 3 / Block Protect 1 (BP1) is set Chip status register: Bit 2 / Block Protect 0 (BP0) is set Chip status register: Write Enable Latch (WEL) is set Chip status register: Write In Progress (WIP/BUSY) is set Resulting block protection : all blocks Found chip "SST SST25VF040B" (512 KB, SPI) at physical address 0xfff80000. [More probings ommited] [UNTESTED status warning ommited] Some block protection in effect, disabling Missing status register write definition, assuming EWSR is needed Reading flash... ftdi_write_data: -110, usb bulk write failed send_buf failed at end: 1 Read operation failed! FAILED.
As you can see, i tried to low the SPI speed to 2MHz. Any idea? I know this part is marked as UNTESTED, but it should work as SST25VF080B do.
Thanks, Carlos