On Wed, Dec 6, 2017 at 8:29 PM, David Velasco david@bemusic.al wrote:
Hi carl,
I have the following error:
# flashrom --programmer internal flashrom v0.9.9-rc1-r1942 on Linux 4.10.0-40-generic (x86_64) flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK. WARNING: *No chipset found. Flash detection will most likely fail.* No EEPROM/flash device found. Note: flashrom can never write if the flash chip isn't found automatically. # flashrom --programmer internal flashrom v0.9.9-rc1-r1942 on Linux 4.10.0-40-generic (x86_64) flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK. WARNING: No chipset found. Flash detection will most likely fail. No EEPROM/flash device found. Note: flashrom can never write if the flash chip isn't found automatically. # flashrom flashrom v0.9.9-rc1-r1942 on Linux 4.10.0-40-generic (x86_64) flashrom is free software, get the source code at https://flashrom.org
Please select a programmer with the --programmer parameter. Previously this was not necessary because there was a default set. To choose the mainboard of this computer use 'internal'. Valid choices are: internal, dummy, nic3com, nicrealtek, gfxnvidia, drkaiser, satasii, atavia, it8212, serprog, buspirate_spi, dediprog, rayer_spi, pony_spi, nicintel, nicintel_spi, nicintel_eeprom, ogp_spi, satamv, linux_spi, pickit2_spi, ch341a_spi.
I can give you the result of
lspci -nnvvvxxx
Yes, please copy + paste lspci output to https://paste.flashrom.org/ .