On 04.07.2010 14:56, Melchior FRANZ wrote:
Here's my report for:
NVIDIA MCP65 MSI MS-7369 "K9N Neo V2" v1.0 (2007)
After the -V run the machine still booted and behaves normally. :-) Here the relevant lines from the output:
Found chipset "NVIDIA MCP65", enabling flash write... chipset PCI ID is 10de:0441 ISA/LPC bridge reg 0x8a contents: 0x40, bit 6 is 1, bit 5 is 0 Guessed flash bus type is SPI Found SMBus device 10de:0446 at 00:01:1 SPI BAR is at 0xfec80000, after clearing low bits BAR is at 0xfec80000 SPI control is 0x0002, enable=0, idle=0
Probing for Winbond W25x80, 1024 KB: probe_spi_rdid_generic: id1 0xef, id2 0x3014 Chip status register is 00 Found chip "Winbond W25x80" (1024 KB, SPI) at physical address 0xfff00000.
m.
Not sure if that's relevant, but I seem have the same board and my results differ:
--- Probing for Macronix MX25L8005, 1024 KB: probe_spi_rdid_generic: id1 0xc2, id2 0x2014 Chip status register is 00 Chip status register: Status Register Write Disable (SRWD) is not set Chip status register: Bit 6 is not set Chip status register: Bit 5 / Block Protect 3 (BP3) is not set Chip status register: Bit 4 / Block Protect 2 (BP2) is not set Chip status register: Bit 3 / Block Protect 1 (BP1) is not set Chip status register: Bit 2 / Block Protect 0 (BP0) is not set Chip status register: Write Enable Latch (WEL) is not set Chip status register: Write In Progress (WIP/BUSY) is not set Found chip "Macronix MX25L8005" (1024 KB, SPI) at physical address 0xfff00000. ---
See my other reply from July 3 for the full output.
HTH -Kjell