Hello Max,
On 10/28/18 6:59 PM, M.Altschaeffel@gmx.de wrote:
Hi, i have a problem with flashing a new blank bios chip. It´s a MX25L3206E chip.
the failed byte counts in the log look rather random, which usually means the hardware setup is failing. Did you try to read+verify with this setup? only if reading is 100% reliable, writing will work.
Do you have the plain chip connected or is it already soldered to the board? If the former, make sure to connect all input pins, i.e. /HOLD and /WP too. If the latter, power supply can be a problem; using the regular laptop PSU works best (might have to get it into a wake-on-lan state). Also, the T530 lacks pull-ups on the /CS lines of both flash chips. If that is the case for the T430 too, idk, but if, you should make sure that the /CS of the chip you _don't_ want to access is pulled high.
Hope that helps, Nico