Hello flashrom developers!
I am currently hacking flashrom support for a National Instrments USB-8451 USB-SPI converter. I have found an AT25DF081A in the drawer to be used as a medical rabbit for my experiments. Probing, reading works fine, but the chip is sector protected. The flashrom tries to disable the protection with clearing the 7th bit (SPRL) in the status register, but as the datasheet states: / / /As a safeguard against accidental or erroneous locking or unlocking of sectors, the Sector Protection Registers can themselves be locked from updates by using the SPRL (Sector Protection Registers Locked) bit of the Status Register (refer to "Status Register Commands" on page 16 for more details). If the Sector Protection Registers are locked, then any attempts to issue the Unprotect Sector command will be ignored, and the device will reset the WEL bit in the Status////Register back to a logical "0" and return to the idle state once the CS pin has been deasserted.// / So to unlock my flash I would have to walk through the sectors and issue an Unprotect sector command with the sector's address. My problem is that the erase blocks addresses and the sector addresses are different things. In my case it has 64Kbyte block feature and the sectors are 64Kbyte, but it also has 4KByte block feature too.
What would you recommend how to implement the sector unlocking mode? My proposal is the following: - Add a sector describing structure to the flashchip structure. It would contain the sector count and sector size. - Create a new unlock method: spi_disable_blockprotect_at2x_sector_unprotect for e.g. which clears the SPRL, then (if SWP is not 0) loops through the sectors and unlock them. - If we want to be nice after the write we can reprotect the device.
Please let me know your opinion on this topic! Thanks!