flashrom v0.9.7-r1711 on Linux 3.17.7-gentoo (x86_64) flashrom is free software, get the source code at http://www.flashrom.org
flashrom was built with libpci 3.2.0, GCC 4.8.3, little endian Command line (3 args): flashrom --programmer internal -V Calibrating delay loop... OS timer resolution is 1 usecs, 1594M loops per second, 10 myus = 10 us, 100 myus = 100 us, 1000 myus = 1001 us, 10000 myus = 10005 us, 4 myus = 4 us, OK. Initializing internal programmer No coreboot table found. DMI string system-manufacturer: "Notebook " DMI string system-product-name: "W840SU Series " DMI string system-version: "Not Applicable " DMI string baseboard-manufacturer: "Notebook " DMI string baseboard-product-name: "W840SU Series " DMI string baseboard-version: "Not Applicable " DMI string chassis-type: "Laptop" Laptop detected via DMI. W836xx enter config mode worked or we were already in config mode. W836xx leave config mode had no effect. Active config mode, unknown reg 0x20 ID: 85. Please send the output of "flashrom -V" to flashrom@flashrom.org with W836xx: your board name: flashrom -V as the subject to help us finish support for your Super I/O. Thanks. Found ITE EC, ID 0x8587, Rev 0x06 on port 0x2e. ======================================================================== WARNING! You seem to be running flashrom on an unsupported laptop. Laptops, notebooks and netbooks are difficult to support and we recommend to use the vendor flashing utility. The embedded controller (EC) in these machines often interacts badly with flashing. See the manpage and http://www.flashrom.org/Laptops for details.
If flash is shared with the EC, erase is guaranteed to brick your laptop and write may brick your laptop. Read and probe may irritate your EC and cause fan failure, backlight failure and sudden poweroff. You have been warned. ======================================================================== Aborting. Error: Programmer initialization failed.